Weber 55052 0100 Install the right end trim piece with tool holders, Right swing-up work surface

Page 18

Installing Features

Install the right end trim piece with tool holders

3.) Insert one end of the swing-up work surface rod

and right swing-up work surface

into the hole in the frame.

You will need: Right trim piece with tool holders, right

 

swing-up work surface, swing-up work surface rod, one

 

1/2 inch bolt, one nylon washer and a wrench

 

1.) Start the right end trim piece into the frame as

 

shown, do not push the trim piece in all of the

 

way and do not add bolt yet.

 

(1)

2.) Slide the swing-up work surface rod through the holes at the top of the swing-up work surface.

C069.a

C-1

 

Image 18
Contents Gas Grill Liquid Propane GAS Units only Customer Service Center South Hicks RoadPalatine, IL Contents For Installation in Canada StorageOperating Genesis Silver-C LP Page Page Page Page Assemble wheel frame Assemble frameYou will need caster frame and wheel frame Continue frame assemblyComplete frame assembly Add front panelAdd cooking box assembly Insert castersInstall cylinder panel Frame brace2Add fuel gauge Install igniter Check that all burner valves are offYou will need burner control knobs Install manifold bracket Install the slide out bottom trayYou will need manifold bracket Install Lid You will need lid, two hair pin cotters1 and two hinge pins2Install the right end trim piece with tool holders Right swing-up work surfaceDo not use the swing-up work surface as a cutting BoardInstall side burner You will need side burnerInstall the left end trim piece and swing-up work Shown, do not push the trim piece in allWay and do not add bolts yet Install the work surface You will need work surfaceDo not use the work surface as a cutting board Regulator coupling and could cause a gas leak Connection. Using a wrench could damageFill liquid propane cylinder Closed. Close by turning clockwiseFlames in the area while you check for Do not use an open flame to check for gasLeaks. Be sure there are no sparks or open Leaks. Sparks or open flames will resultInstall the thermometer You will need ThermometerYou will need Bottom shelf Lighting To ExtinguishSummary lighting instructions are on the control panel Manual Lighting Lighting the Side Burner Lighting only the side burnerCleaning CookingStorage and/or Nonuse Refilling the Liquid Propane Cylinder Removal of the LP cylinderImportant LP Cylinder Information To Connect the hose to the cylinder Liquid Propane CylinderSafe handling tips for Liquid Propane Gas Cylinders Liquid Propane LP CylindersLiquid Propane Cylinder requirements Annual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsGeneral Maintenance Main Burner Cleaning ProcedureWeber Spider Stopper Guards Replacing Main Burners Crossover Ignition System Operations Burners burn with a yellow or Barbecue temperature onlyFlame is low when burner is on Orange flame, in conjunction withFlame is very yellow Side Burner does not lightFlame is low in High position Conjunction with the smell of gas