Weber 55052 0100, Liquid Propane Grill manual Install the work surface, You will need work surface

Page 22

4.) While holding swing-up work surface in position,

To raise swing-up work surface: Lift table all the way up

insert the other end of the swing-up work surface

and slide it to the right, then lower table until you feel it

rod into the left end trim piece. Push the trim piece

lock in the up position.

into the frame.

 

 

To lower swing-up work surface: Lift table up until it

 

disengages and slide it to the left. Then lower it all the

 

way down so that the locking pin on the right side of

 

the table fits into the locking bracket on the leg, which

 

will secure the table in the down position.

 

Do not use the swing-up work surface as a cutting

 

board.

5.) Add a washer to the bolt and insert it through the hole in the frame and the hole in the trim piece. Tighten with a wrench.

Install the work surface

You will need: work surface.

Place the work surface, so that the front and back edges fit over the frame, in the area between the left trim piece and the cooking box as shown.

Do not use the work surface as a cutting board.

(1)

(1) Make sure that the tabs on the side table are to the right, next to the cooking box.

C-5

Image 22
Contents Gas Grill Liquid Propane GAS Units only South Hicks Road Customer Service CenterPalatine, IL Contents Storage For Installation in CanadaOperating Genesis Silver-C LP Page Page Page Page Assemble wheel frame Assemble frameYou will need caster frame and wheel frame Continue frame assemblyComplete frame assembly Add front panelAdd cooking box assembly Insert castersFrame brace2 Install cylinder panelAdd fuel gauge Check that all burner valves are off Install igniterYou will need burner control knobs Install the slide out bottom tray Install manifold bracketYou will need manifold bracket Install Lid You will need lid, two hair pin cotters1 and two hinge pins2Install the right end trim piece with tool holders Right swing-up work surfaceDo not use the swing-up work surface as a cutting BoardInstall side burner You will need side burnerShown, do not push the trim piece in all Install the left end trim piece and swing-up workWay and do not add bolts yet You will need work surface Install the work surfaceDo not use the work surface as a cutting board Regulator coupling and could cause a gas leak Connection. Using a wrench could damageFill liquid propane cylinder Closed. Close by turning clockwiseFlames in the area while you check for Do not use an open flame to check for gasLeaks. Be sure there are no sparks or open Leaks. Sparks or open flames will resultYou will need Thermometer Install the thermometerYou will need Bottom shelf To Extinguish LightingSummary lighting instructions are on the control panel Manual Lighting Lighting the Side Burner Lighting only the side burnerCooking CleaningStorage and/or Nonuse Removal of the LP cylinder Refilling the Liquid Propane CylinderImportant LP Cylinder Information To Connect the hose to the cylinder Liquid Propane CylinderLiquid Propane LP Cylinders Safe handling tips for Liquid Propane Gas CylindersLiquid Propane Cylinder requirements Annual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsMain Burner Cleaning Procedure General MaintenanceWeber Spider Stopper Guards Replacing Main Burners Crossover Ignition System Operations Burners burn with a yellow or Barbecue temperature onlyFlame is low when burner is on Orange flame, in conjunction withFlame is very yellow Side Burner does not lightFlame is low in High position Conjunction with the smell of gas