Weber 55052 0100, Liquid Propane Grill Install manifold bracket, You will need manifold bracket

Page 16

Install manifold bracket

You will need: manifold bracket.

Hook the bracket(2) onto the manifold at the center burner valve. Place your hand underneath the bracket. Lift the manifold, bracket and cooking box slightly, then hook the tab of the bracket onto the frame brace(1).

(1)(2)

Install the slide out bottom tray

You will need: the slide out bottom tray(1), catch pan holder(2), catch pan and one disposable drip pan.

(1)

(2)

Hook the ends of the catch pan holder into the hole in the slide out bottom tray. The front of the catch pan holder must be on the same side as the finger grip(1) of the bottom tray.

(1)

Slide the bottom tray onto the mounting rails under the cooking box with finger grip toward you(1).

￿WARNING: Do not line bottom tray with alumi- num foil. It can cause grease fires by trapping the grease and not allowing grease to flow into the catch pan.

(1)

Put the disposable drip pan into the catch pan. Slide the catch pan into the catch pan holder with its finger grip towards you(1).

B-6

Image 16
Contents Gas Grill Liquid Propane GAS Units only South Hicks Road Customer Service CenterPalatine, IL Contents Storage For Installation in CanadaOperating Genesis Silver-C LP Page Page Page Page Assemble wheel frame Assemble frameContinue frame assembly Complete frame assemblyYou will need caster frame and wheel frame Add front panelAdd cooking box assembly Insert castersFrame brace2 Install cylinder panelAdd fuel gauge Check that all burner valves are off Install igniterYou will need burner control knobs Install the slide out bottom tray Install manifold bracketYou will need manifold bracket Install Lid You will need lid, two hair pin cotters1 and two hinge pins2Install the right end trim piece with tool holders Right swing-up work surfaceDo not use the swing-up work surface as a cutting BoardInstall side burner You will need side burnerShown, do not push the trim piece in all Install the left end trim piece and swing-up workWay and do not add bolts yet You will need work surface Install the work surfaceDo not use the work surface as a cutting board Connection. Using a wrench could damage Fill liquid propane cylinderRegulator coupling and could cause a gas leak Closed. Close by turning clockwiseDo not use an open flame to check for gas Leaks. Be sure there are no sparks or openFlames in the area while you check for Leaks. Sparks or open flames will resultYou will need Thermometer Install the thermometerYou will need Bottom shelf To Extinguish LightingSummary lighting instructions are on the control panel Manual Lighting Lighting the Side Burner Lighting only the side burnerCooking CleaningStorage and/or Nonuse Removal of the LP cylinder Refilling the Liquid Propane CylinderImportant LP Cylinder Information To Connect the hose to the cylinder Liquid Propane CylinderLiquid Propane LP Cylinders Safe handling tips for Liquid Propane Gas CylindersLiquid Propane Cylinder requirements Annual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsMain Burner Cleaning Procedure General MaintenanceWeber Spider Stopper Guards Replacing Main Burners Crossover Ignition System Operations Barbecue temperature only Flame is low when burner is onBurners burn with a yellow or Orange flame, in conjunction withSide Burner does not light Flame is low in High positionFlame is very yellow Conjunction with the smell of gas