TROUBLESHOOTING
PROBLEM | CHECK | SOLUTION |
|
|
|
Burners burn with a yellow or orange flame, in | Inspect Spider/Insect screens for possible obstructions.. | Clean Spider/Insect screens.. Refer to “ANNUAL |
conjunction with the smell of gas. | (Blockage of holes..) | MAINTENANCE”.. |
|
|
|
Burner does not light, or flame is low in HI position. | Is fuel hose bent or kinked? | Straighten fuel hose.. |
|
|
|
Burner does not ignite when you push the igniter | Be sure that there is gas flow to the burners by | If match lighting is successful, the problem lies in the |
button. | attempting to match light your burners.. Refer to “MAIN | ignition system.. Refer to “ELECTRONIC IGNITION |
| BURNER MANUAL IGNITION”.. | SYSTEMS OPERATIONS”.. |
|
|
|
| Is there a fresh battery installed? | Verify that the battery is in good condition and installed |
|
| correctly.. Refer to “ELECTRONIC IGNITER INSPECTION”.. |
|
|
|
| Are the wires connected properly to the ignitior module? | Be sure that wires are correctly inserted into terminals |
|
| on ignition box.. Refer to “ELECTRONIC IGNITION |
|
| SYSTEMS OPERATIONS”.. |
|
|
|
| Is there plastic wrapping around the new battery? | Remove plastic wrapping.. |
|
|
|
Experiencing | Are you preheating barbecue in the prescribed manner? | All burners on HI for 10 to 15 minutes for preheating.. |
m CAUTION: Do not line the slide out |
|
|
Are the cooking grates, heat deflectors and Flavorizer® | Clean thoroughly.. Refer to “CLEANING”.. | |
grease tray with aluminum foil. | bars heavily coated with |
|
|
| |
| Is the slide out grease tray dirty and not allowing grease | Clean slide out grease tray.. |
| to flow into catch pan? |
|
|
|
|
Burner flame pattern is erratic. Flame is low when | Are burners clean? | Clean burners.. Refer to “MAINTENANCE”.. |
burner is on HI. Flames do not run the whole length |
|
|
of the burner tube. |
|
|
|
|
|
Inside of lid appears to be “peeling.” | The inside of the lid is porcelain enamel or stainless | Clean thoroughly.. Refer to “CLEANING”.. |
(Resembles paint peeling.) | steel, and is not painted.. It cannot “peel”.. What you are |
|
| seeing is baked on grease that has turned to carbon and |
|
| is flaking off.. |
|
| THIS IS NOT A DEFECT. |
|
|
|
|
Cabinet doors are not aligned. | Check the adjustment pin on the bottom of each door.. | Loosen adjustment nut/s.. Slide door/s until aligned.. |
|
| Tighten nut.. |
|
|
|
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.
16