Type of GAS, What is Natural GAS? | Weber S-620/650 manual

GAS INSTRUCTIONS	15

TYPE OF GAS

Your natural gas grill is factory built to operate using natural gas only. Never attempt to operate your grill on gases other than the type speciﬁ ed on the grill rating plates.

Your grill operates at 4.5” of water column pressure. If replacement of the hose becomes necessary, factory speciﬁ ed parts are required. See your local dealer.

For safety and design reasons, the conversion of a Weber® grill from operation using Natural gas to operation using LP gas requires the change out of the entire gas supply system of the grill. If this becomes necessary, see your dealer for additional information.

WHAT IS NATURAL GAS?

Natural gas, often called methane, is a safe modern fuel. Natural gas is supplied by your local utility and should be readily available if your house is already heated with gas.

PORTABLE INSTALLATION

Weber® recommends moving the grill at least two (2) feet from the gas supply and any combustible surfaces. After the gas supply has been run and checked for leaks in accordance to the assembly instructions, you are ready to grill. To connect the hose to the gas supply, pull back the outer ﬁtting, insert the hose ﬁ tting all of the way, and release the outer ﬁ tting. This process will produce a gas joint.

LEAK CHECK PREPARATION

CHECK THAT ALL BURNER VALVES ARE OFF

Valves are shipped in the “OFF” position, but you should check to be sure that they are turned off. Check by pushing in and turning clockwise. If they do not turn, they are off. Proceed to the next step. If they do turn continue turning them clockwise until they stop, then they are off. Proceed to the next step.

3	4	5	2	6	1

1					Swivel Connection

2			Install covers when hose is disconnected

3							Shut Off Valve

4		Coat this pipe nipple with gas resistant pipe dope
5								Socket
6						Male Connection
	2
	1
				3					4
				3					4

1	Socket
2	Sleeve
3	Push Sleeve Back
4	Plug

Push plug until sleeve snaps forward locking plug in socket.

(This turns on gas automatically.)

When properly assembled the plug cannot be removed without pushing

the sleeve back.

To disconnect, push sleeve back and pull out plug.

(This automatically shuts off gas.)

CHECK FOR GAS LEAKS

WARNING: The gas connections of your Summit® gas grill have been factory tested. We do however recommend that you leak check all gas connections before operating your Summit® gas grill.

REMOVE CONTROL PANEL

Part required: Phillips Screwdriver.

1) Remove the burner control knobs.

GAS INSTRUCTIONS