Weber 1500 owner manual Assemble the frame, Continue frame assembly

Page 13

Step 2

Assemble the frame

You will need: left frame, right frame, two nylon washers, two 1/4-20 x 1/2 inch bolts and a 7/16 inch wrench.

Note - Work on carpeted area (on grass, or on one of the boxes) to protect the finish during frame assembly.

Put the frame pieces so the leg tabs are up. Put the right frame to your right and left frame to your left. Figure 1.

Slip the two frame halves together with the tabs inside, until the tabs of the right frame are inside the left frame and the holes align. Figure 1 (a).

Slip washers over bolts; insert and tighten bolts. (If you try to insert a bolt and there are no holes, you have the left frame turned the wrong way. Turn the left frame around.) Figure 1 (b).

(a)

(b)

Figure 1

Step 3

Continue frame assembly

You will need: frame assembly, two side frames, four 1/4-20 x 1/2 inch bolts, four nylon washers and a 7/16 inch wrench.

Assemble one side frame onto the leg tabs of the right frame, and the second side frame onto the leg tabs of the left frame. Make sure the anchoring base plates are facing in toward each other. The tabs must be on the inside of the frames when the joints are closed.

Add washers, then bolts. Do not fully tighten these bolts. You will tighten them once the base is anchored. Figure 2 (a).

Turn frame assembly right side up.

(a)

Anchoring base

plates are facing in

Do not fully tighten

these bolts

Figure 2

13

Image 13
Contents Genesis LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents General Instructions Gas supply testingStorage Operating areaGeneral Specifications for Piping Typical natural gas supply installation to a wood deck Recommended concrete pad requirements Check package contents AssemblyStep Page Check contents of hardware packs Assemble the frame Continue frame assemblyMCAUTION a minimum of 2 bolts are required on each side Measure and drill holesMethod 2 Concrete Method 1 ConcreteMethod 3 Concrete Method 4 Wood deck Add cooking box Connect barbecue gas supply line to the natural gas supply Install manifold bracketCheck all valves are off Purge air from gas lines Install igniterMWARNING Do not ignite burners while leak checking Check for gas leaksAdd base panel Install side panelsInstall the bottom tray Install Flavorizer Bars and Cooking GratesAdd tool holders, control panel and burner control knobs Install LidInstall the accessory rack Install the condiment basketComplete accessory installation To Extinguish LightingManual Lighting Cooking Periodic CleaningAfter a Period of Nonuse Drippings and greaseInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMCAUTION Do not enlarge the burner ports when cleaning General MaintenanceWeber Spider Stopper Guards Main Burner Flame PatternReconnect gas supply line. See Check for gas leaks Crossover Ignition System Operations MCAUTION Do not line the bottom tray with aluminum foil Burner does not light, or flame is low in High position43-47 Parts List Final Word Thanks