Weber 1500 owner manual Method 1 Concrete, Method 2 Concrete, Method 3 Concrete

Page 15

Typical installation of the base for an existing concrete patio, new pad or wood deck (continued)

Method 1 - Concrete

A strike anchor, a minimum size of 3/8 inch x 3 1/2 inches long with a 3/8 inch flat washer and 3/8 inch nut. Figure 6.

Note - Use a 3/8 inch diameter concrete drill bit for drilling the hole for the strike anchor.

Strike anchor

3/8 inch nut

3/8 inch flat washer

Mount plate

Drilled hole

Figure 6

Method 2 - Concrete

A concrete lag bolt, a minimum of 3/8 inch x 2 1/2 inches long with a 3/8 inch diameter long lag shield and a 3/8 inch flat washer. Figure 7.

Note - Use a 5/8 inch concrete drill bit for drilling the hole for the lag shield.

Concrete lag bolt

3/8 inch flat washer

Mount plate

Lag shield

Drilled hole

Figure 7

Method 3 - Concrete

A 3/8 inch machine screw anchor, using a 3/8-16 x

1 1/2 inch machine screw and a flat washer. Figure 8.

Note - Use a 3/4 inch diameter concrete drill bit for drilling the hole for the screw base. The machine screw anchor requires a setting tool.

3/8-16 x 1 1/2 machine screw 3/8 inch flat washer

Mount plate

3/8 inch screw anchor

Drilled hole

Figure 8

15

Image 15

Contents Genesis LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents Operating area Gas supply testingGeneral Instructions StorageGeneral Specifications for Piping Typical natural gas supply installation to a wood deck Recommended concrete pad requirements Assembly Check package contentsStep Page Check contents of hardware packs Assemble the frame Continue frame assemblyMCAUTION a minimum of 2 bolts are required on each side Measure and drill holesMethod 1 Concrete Method 2 ConcreteMethod 3 Concrete Method 4 Wood deck Add cooking box Install manifold bracket Connect barbecue gas supply line to the natural gas supplyCheck all valves are off Purge air from gas lines Install igniterMWARNING Do not ignite burners while leak checking Check for gas leaksAdd base panel Install side panelsInstall the bottom tray Install Flavorizer Bars and Cooking GratesAdd tool holders, control panel and burner control knobs Install LidInstall the accessory rack Install the condiment basketComplete accessory installation To Extinguish LightingManual Lighting Drippings and grease Periodic CleaningCooking After a Period of NonuseInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMain Burner Flame Pattern General MaintenanceMCAUTION Do not enlarge the burner ports when cleaning Weber Spider Stopper GuardsReconnect gas supply line. See Check for gas leaks Crossover Ignition System Operations MCAUTION Do not line the bottom tray with aluminum foil Burner does not light, or flame is low in High position43-47 Parts List Final Word Thanks