Weber 1500 owner manual Method 4 Wood deck

Page 16
Step 6
Add front panel and tighten all frame bolts You will need: front panel and two plastic buttons.
Align the panel with the holes in the frame and insert the plastic buttons through the front panel and frame.
Figure 11.
Plastic buttons shown from the rear of the barbecue
Figure 11
Fully tighten the 1/4-20 bolts in the frame assembly, that you only started in Step “Continue Frame Assembly” Figure 12.
Figure 12

Typical installation of the base for an existing concrete patio, new pad or wood deck (continued)

Method 4 - Wood deck

After assembling the base according to the assembly instructions, position the base assembly on your deck for anchoring.

mCAUTION: Combustible materials should never be within 24 inches of the top, bottom, back or sides of the barbecue. Do not locate under overhead combustible construction.

mCAUTION: For a deck installation, it is recommended to anchor one screw into a joist.

Note - With the lid open, the depth of the barbecue is 28 inches, front to back.

Anchor the base to the deck. We recommend using a minimum of a 3/8 inch x 1 1/2 inch lag bolt with a 3/8 inch flat washer. Figure 9.

Note - Use a 3/16 inch drill bit for drilling a pilot hole for a 3/8 inch lag bolt.

3/8 inch x 1 1/2 inch lag bolt

3/8 inch flat washer

Mount plate

Drilled hole

Figure 9

mWARNING: Whichever method used, the base must be bolted down (anchored) at a minimum of four anchoring points (two per side) prior to barbecue assembly. One anchor in each corner of the base plate. Figure 10.

1

4

2

3

Figure 10

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Genesis MDANGER MWARNINGS LP GAS Units onlyWarranty Patents and Trademarks Contents Gas supply testing General InstructionsStorage Operating areaGeneral Specifications for Piping Typical natural gas supply installation to a wood deck Recommended concrete pad requirements Check package contents AssemblyStep Page Check contents of hardware packs Continue frame assembly Assemble the frameMeasure and drill holes MCAUTION a minimum of 2 bolts are required on each sideMethod 2 Concrete Method 1 ConcreteMethod 3 Concrete Method 4 Wood deck Add cooking box Connect barbecue gas supply line to the natural gas supply Install manifold bracketCheck all valves are off Install igniter Purge air from gas linesCheck for gas leaks MWARNING Do not ignite burners while leak checkingInstall side panels Add base panelInstall Flavorizer Bars and Cooking Grates Install the bottom trayInstall Lid Add tool holders, control panel and burner control knobsInstall the condiment basket Install the accessory rackComplete accessory installation Lighting To ExtinguishManual Lighting Periodic Cleaning CookingAfter a Period of Nonuse Drippings and greaseAnnual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsGeneral Maintenance MCAUTION Do not enlarge the burner ports when cleaningWeber Spider Stopper Guards Main Burner Flame PatternReconnect gas supply line. See Check for gas leaks Crossover Ignition System Operations Burner does not light, or flame is low in High position MCAUTION Do not line the bottom tray with aluminum foil43-47 Parts List Final Word Thanks
Top Page Image Contents