Weber 1500 owner manual Install Lid, Add tool holders, control panel and burner control knobs

Page 23

Step 18

Install Lid

You will need: lid, two hinge pins and two hair pin cotters.

Set the lid in place. Align the hinges at the rear of the barbecue. Insert hinge pins from the outside. Insert hair pin cotters into the small holes in the hinge pins. Figure 30.

Hair pin cotter

Hinge pin

Figure 30

Step 19

Add tool holders, control panel and burner control knobs

You will need: three tool holders, control panel, two Phillips screws/washers, a Phillips screwdriver, and three burner control knobs.

Hook the tool holders over the frame rail and snap down into place. Figure 31.

Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Line up the holes in the control panel with the holes in the inserts in the frame brace. Insert screws and tighten with a Phillips screwdriver until snug. Do not overtighten. Figure 31 (a).

Push on the burner control knobs. Figure 31 (b).

	Insert in
Crossover	frame brace


Ignition Button (a)

Control panel push-in buttons

(b)

Tool holders

Figure 31

23

Image 23

Contents Genesis LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents Operating area Gas supply testingGeneral Instructions StorageGeneral Specifications for Piping Typical natural gas supply installation to a wood deck Recommended concrete pad requirements Step AssemblyCheck package contents Page Check contents of hardware packs Assemble the frame Continue frame assemblyMCAUTION a minimum of 2 bolts are required on each side Measure and drill holesMethod 3 Concrete Method 1 ConcreteMethod 2 Concrete Method 4 Wood deck Add cooking box Check all valves are off Install manifold bracketConnect barbecue gas supply line to the natural gas supply Purge air from gas lines Install igniterMWARNING Do not ignite burners while leak checking Check for gas leaksAdd base panel Install side panelsInstall the bottom tray Install Flavorizer Bars and Cooking GratesAdd tool holders, control panel and burner control knobs Install LidInstall the accessory rack Install the condiment basketComplete accessory installation To Extinguish LightingManual Lighting Drippings and grease Periodic CleaningCooking After a Period of NonuseInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMain Burner Flame Pattern General MaintenanceMCAUTION Do not enlarge the burner ports when cleaning Weber Spider Stopper GuardsReconnect gas supply line. See Check for gas leaks Crossover Ignition System Operations MCAUTION Do not line the bottom tray with aluminum foil Burner does not light, or flame is low in High position43-47 Parts List Final Word Thanks