Step 8
Connect barbecue gas supply line to the natural gas supply
Note - We recommend that the connection between the barbecue gas supply line and the natural gas supply be flare to flare. A
You will need: barbecue gas supply line, 3/8 inch flare fitting, 3/4 inch and 11/16 inch wrenches.
mWARNING: This barbecue is NOT portable. It must be bolted down at all times when it is connected to a natural gas supply.
Unscrew the 3/8 inch flare fitting from the barbecue gas supply line. Apply pipe sealant to the threads of the pipe fitting. Screw the pipe fitting end of the 3/8 inch flare fitting into the natural gas supply pipe. Tighten with an 11/16 inch wrench. Figure 16 (a).
Attach the flare nut on the barbecue gas supply line to the flare fitting end of the 3/8 inch flare fitting. Tighten with a 3/4 inch wrench. Figure 16 (a).
Attach the flare nut at the other end of the barbecue gas supply line to the manifold fitting. Tighten with a 3/4 inch wrench. Figure 16 (b).
(b)
| Apply pipe |
Figure 16 | sealant here |
| (a) |
Natural Gas
Supply Pipe
Pipe fitting end of
Flare fitting end of
Step 9
Check all valves are off
You will need: one burner control knob.
(Valves are shipped in the OFF position, but you should check to be sure.) Put the knob on each valve. Check by pushing down and turning clockwise. If they do not turn they are off. Proceed to the next step. Figure 17.
Figure 17
Step 10
Install manifold bracket
You will need: manifold bracket.
Hook the bracket onto the manifold at the center burner valve. Figure 18. Place your hand underneath the bracket. Lift the bracket, manifold and cooking box slightly as a unit and hook onto the frame brace. Figure 18 (a).
Frame brace
Manifold bracket
(a)
Figure 18
View from below cooking box
18