Weber 1500 owner manual Assembly, Step, Check package contents

Page 10

Assembly

Step 1

Tools needed

Check package contents

 

Regular screwdriver

 

Phillips screwdriver

Cooking box

(assembly)

 

Hammer

One 7/16 inch or an adjustable wrench

Lid (assembly)

® ®

Pliers

Tape Measure

Pencil

Electric drill

Supplies needed

You will need a soap and water solution to check for gas leaks. (See Step "Check for gas leaks.")

Note - The hardware size of nuts, bolts, and screws is given. For example "1/4-20 x 2 inch bolt" means a bolt 1/4 inch in diameter with 20 threads to the inch, 2 inches long. On a small screw for example, "6-32 x 1/2 inch screw" means a number 6 screw, with 32 threads to the inch, 1/2 inch long.

While we give much attention to our products, unfortunately an occasional error may occur. If a part is missing, do not go back to the store. Call the Weber Customer Service Center toll free 1-800-446-1071to receive immediate assistance. Have your owner’s man- ual and serial number of the barbecue available for reference.

Bottom tray

Control panel

Work table

Gas supply line (with the flare fitting loosely attached

for shipping purposes)

10

Image 10
Contents Genesis MDANGER MWARNINGS LP GAS Units onlyWarranty Patents and Trademarks Contents Storage Gas supply testingGeneral Instructions Operating areaGeneral Specifications for Piping Typical natural gas supply installation to a wood deck Recommended concrete pad requirements Check package contents AssemblyStep Page Check contents of hardware packs Continue frame assembly Assemble the frameMeasure and drill holes MCAUTION a minimum of 2 bolts are required on each sideMethod 2 Concrete Method 1 ConcreteMethod 3 Concrete Method 4 Wood deck Add cooking box Connect barbecue gas supply line to the natural gas supply Install manifold bracketCheck all valves are off Install igniter Purge air from gas linesCheck for gas leaks MWARNING Do not ignite burners while leak checkingInstall side panels Add base panelInstall Flavorizer Bars and Cooking Grates Install the bottom trayInstall Lid Add tool holders, control panel and burner control knobsInstall the condiment basket Install the accessory rackComplete accessory installation Lighting To ExtinguishManual Lighting After a Period of Nonuse Periodic CleaningCooking Drippings and greaseAnnual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsWeber Spider Stopper Guards General MaintenanceMCAUTION Do not enlarge the burner ports when cleaning Main Burner Flame PatternReconnect gas supply line. See Check for gas leaks Crossover Ignition System Operations Burner does not light, or flame is low in High position MCAUTION Do not line the bottom tray with aluminum foil43-47 Parts List Final Word Thanks