Chapter 8: Appendix
8-1 Technical Specifications
Annex B Information
The following design information is provided for your reference:
1.No modifications are allowed to this equipment that could alter the CE compliance
2. | Ambient temperature: | 0 degrees Celsius – Maximum (104 degrees Fahrenheit) | |||||
3. | Environment: | Clean, |
|
| |||
4. |
| Radiation: |
| None |
|
|
|
5. |
| Vibration: |
| Minimal, i.e. machine mounting |
| ||
6. |
| Allowable voltage fluctuation: | +/- 10% |
|
| ||
7. |
| Allowable frequency fluctuation: | Continuous | +/- 1% | |||
|
|
|
|
| Intermittent | +/- 2% |
|
8. |
| Nominal supply voltage: | 460/3/60 (Verify on serial number tag) | ||||
9. | Earth ground type: | TN (system has one point directly earthed through a protective conductor) | |||||
10.Power supply should include a ground connection.
11.
12.The
13.Additive feeder is not equipped with local lighting.
14.Functional identification
15.Additive Feeder is equipped with a CE mark
16.Additive Feeder is supplied with an operating manual in the language of the destination country.
17.Cable support may be required for power cord, depending on final installation.
18.No one is required to be in the interior of the electrical enclosure during the normal operation of the unit. Only skilled electricians should be inside the enclosure for maintenance.
19.Doors can be opened with a screwdriver, but no keys are required.
20.
21.All additive feeders should be moved around and set in a place with a lift truck or equivalent.
22.There are no frequent repetitive cycles that require manual control⎯repetitive functions are automatic while the additive feeder is operating.
23.An inspection report detailing the functional test is included with the additive feeder.
24.The machine is not equipped with cableless controls.
25.
Additive Feeders | Chapter 8: Appendix | 46 of 55 |