Sterling SSE-5 BL operating instructions Changing the sealing ring of the outlet flap

Page 25

SSE 5 BL

5.2.1. Changing the sealing ring of the outlet flap

Remove the connecting plug “flap switch” (A)

Remove the tension ring (B) and the sealing ring (C).

Remove the upper part of the hopper loader (D) from the lower part (E).

Draw the old sealing ring (F) off the nozzle of the material outlet.

Install the new sealing ring (F)

FObserve the direction of installation (G).

Install the upper part of the hopper loader (D) on the lower part (E). Install the sealing ring (C) and the tension ring (B) on the hopper loader.

Connect the connecting plug “flap switch” (A) to the connection housing of the hopper. Install the unit.

&Order number sealing ring “material outlet”: ID 23098

Figure 0: Installation sealing ring

Maintenance 11

Image 25

Contents Operating Instructions Single Conveyor Unit SSE-5 BL SSE 5 BL SSE 5 BL Parts and Service Department Table of contents Technical data Spare parts list SSE-2 General instructions SSE 5 BL Legal basis Explanations and informationFields of applications Safety instructions General For your safetyAssembly Operation MaintenanceFor the operating safety of the equipment Putting into operation Checking the pipe system If the conditions points 3 + 4 are met Adjusting the suction pipesSetting the controller Initial conveying operations Switching off the unitError and error correction When the malfunction has been corrected press the key Maintenance SSE 5 BL Servicing the conveyor Maintenance intervalsChanging the sealing ring of the outlet flap Observe the direction of installation GOutlet flap Adjusting the flap switchOrder number Cleaning the unitFilter cloth Wire cloth Functional description General Controller ControllerSSE 5 BL Transport, Assembly and Storage Transport and Packing AssemblyStorage Assembly instructions CSE 5 BL Assembly Mounting onto a machine hopper Mounting on the processing machineMounting onto dosing station DT Mounting onto mixing hoppers with lateral inletMounting the suction pipe MV Material feedElectrical connection PipeworkInstallation of the signal line of the SKW optional Installation of the flap switch signal lineInstallation of the alarm indicating device optional Compressed-air supply Installing the accessoriesTechnical data SSE 5/BL Dimension Sheet Spare parts list SSE-f/BL, 230 V, 50 Hz Pos Order no Designation Wear Code SSE-5/BL, 230 V, 50 HzAccessories Accessories Electrical manual SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL