Sterling SSE-5 BL Adjusting the suction pipes, If the conditions points 3 + 4 are met

Page 17

SSE 5 BL

3.2. Adjusting the suction pipes

The suction pipes have to be adjusted exactly to ensure troublefree operation.

1. Set the suction pipes to their home position.

&At home position the inner pipe of the suction pipe protrudes about 120-160 mm (4.75" - 6.25") from the outer pipe at the top end.

2. Start a conveying operation.

Connect the unit to mains supply by the device plug.

3. Observe the flexible hose at the suction pipe.

The flexible hose must not show any pulsating movement

4. Observe the flexible hose at the separator.

The conveying hose must only move during in-feed.

If the conditions (points 3 + 4) are not met:

Pull the inner pipe further out of the outer pipe until there is no more jerky conveyance.

If the conditions (points 3 + 4) are met:

Push the inner pipe slowly into the outer pipe until pulsating of the flexible hose or shock conveyance occurs.

Now pull the inner pipe slightly back again until the hose stop pulsating.

Select a setting between the two pipes to ensure that enough air can flow into the material pipe. Once you have reached a satisfactory conveying result turn the wing screw at the suction pipe tight.

Putting into operation 3-3

Image 17

Contents Operating Instructions Single Conveyor Unit SSE-5 BL SSE 5 BL SSE 5 BL Parts and Service Department Table of contents Technical data Spare parts list SSE-2 General instructions SSE 5 BL Fields of applications Explanations and informationLegal basis Safety instructions General For your safetyAssembly Operation MaintenanceFor the operating safety of the equipment Putting into operation Checking the pipe system If the conditions points 3 + 4 are met Adjusting the suction pipesSetting the controller Initial conveying operations Switching off the unitError and error correction When the malfunction has been corrected press the key Maintenance SSE 5 BL Servicing the conveyor Maintenance intervalsChanging the sealing ring of the outlet flap Observe the direction of installation GOutlet flap Adjusting the flap switchOrder number Cleaning the unitFilter cloth Wire cloth Functional description General Controller ControllerSSE 5 BL Transport, Assembly and Storage Storage AssemblyTransport and Packing Assembly instructions CSE 5 BL Assembly Mounting onto a machine hopper Mounting on the processing machineMounting onto dosing station DT Mounting onto mixing hoppers with lateral inletMounting the suction pipe MV Material feedElectrical connection PipeworkInstallation of the signal line of the SKW optional Installation of the flap switch signal lineInstallation of the alarm indicating device optional Compressed-air supply Installing the accessoriesTechnical data SSE 5/BL Dimension Sheet Spare parts list SSE-f/BL, 230 V, 50 Hz Pos Order no Designation Wear Code SSE-5/BL, 230 V, 50 HzAccessories Accessories Electrical manual SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL