Sterling SSE-5 BL operating instructions When the malfunction has been corrected press the key

Page 21

SSE 5 BL

If a disturbance occurs in the unit, an alarm message will be issued (option, only if the alarm indicating device has been activated).

&An “E” appears in the display and an error number. The alarm indicating device (signal siren, horn) reacts.

FThe control system can only restart operation when the malfunction has been corrected.

Press the “acknowledgement key”.

&The cause of the malfunction will not be corrected by pressing the “acknowledgement key”.

The following error messages can be displayed:

“E1"

The alarm message “E1" is displayed when no material has been conveyed during 3 consecutive conveying cycles.

Check that sufficient material is being conveyed. Check that the flap switch is set correctly.

FWhen the malfunction has been corrected press the key.

“E2"

If the control system becomes too hot during operation (>70°C, 158°F) the “E2" alarm message is displayed and the unit is switched off.

Ensure that the control system is sufficient cooled.

Error and error correction 7

Image 21

Contents Operating Instructions Single Conveyor Unit SSE-5 BL SSE 5 BL SSE 5 BL Parts and Service Department Table of contents Technical data Spare parts list SSE-2 General instructions SSE 5 BL Explanations and information Legal basisFields of applications Safety instructions General For your safetyAssembly Operation MaintenanceFor the operating safety of the equipment Putting into operation Checking the pipe system If the conditions points 3 + 4 are met Adjusting the suction pipesSetting the controller Initial conveying operations Switching off the unitError and error correction When the malfunction has been corrected press the key Maintenance SSE 5 BL Servicing the conveyor Maintenance intervalsChanging the sealing ring of the outlet flap Observe the direction of installation GOutlet flap Adjusting the flap switchOrder number Cleaning the unitFilter cloth Wire cloth Functional description General Controller ControllerSSE 5 BL Transport, Assembly and Storage Assembly Transport and PackingStorage Assembly instructions CSE 5 BL Assembly Mounting onto a machine hopper Mounting on the processing machineMounting onto dosing station DT Mounting onto mixing hoppers with lateral inletMounting the suction pipe MV Material feedElectrical connection PipeworkInstallation of the signal line of the SKW optional Installation of the flap switch signal lineInstallation of the alarm indicating device optional Compressed-air supply Installing the accessoriesTechnical data SSE 5/BL Dimension Sheet Spare parts list SSE-f/BL, 230 V, 50 Hz Pos Order no Designation Wear Code SSE-5/BL, 230 V, 50 HzAccessories Accessories Electrical manual SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL