Sterling SSE-5 BL Mounting on the processing machine, Mounting onto a machine hopper

Page 38

SSE 5 BL

8.2. Mounting on the processing machine

A material hopper VT 2,3/70 / VT 2,8/70 is required: Mount the material hopper onto the flange of the processing machine.

Mount the unit onto the material hopper.

F Figure 6: VT 2,3/70 / VT2,8/70

Observe the bearing capacity of the machine flange.

8.3. Mounting onto a machine hopper

A welding flange EF 190 or an assembly flange MF 253 is required:

LPlease observe all safety regulations for the operation of welding equipments.

Always wear a safety goggle.

Weld the welding flange into the machine hopper lid. Mount the unit onto the flange.

Or

Mount the assembly flange.

Mount the unit onto the flange.

Figure 6: EF 253

Figure 6: MF 253

Assembly instructions 24

Image 38

Contents Operating Instructions Single Conveyor Unit SSE-5 BL SSE 5 BL SSE 5 BL Parts and Service Department Table of contents Technical data Spare parts list SSE-2 General instructions SSE 5 BL Fields of applications Explanations and informationLegal basis Safety instructions For your safety GeneralAssembly Maintenance OperationFor the operating safety of the equipment Putting into operation Checking the pipe system Adjusting the suction pipes If the conditions points 3 + 4 are metSetting the controller Switching off the unit Initial conveying operationsError and error correction When the malfunction has been corrected press the key Maintenance SSE 5 BL Maintenance intervals Servicing the conveyorObserve the direction of installation G Changing the sealing ring of the outlet flapAdjusting the flap switch Outlet flapCleaning the unit Order numberFilter cloth Wire cloth Functional description General Controller ControllerSSE 5 BL Transport, Assembly and Storage Storage AssemblyTransport and Packing Assembly instructions CSE 5 BL Assembly Mounting on the processing machine Mounting onto a machine hopperMounting onto mixing hoppers with lateral inlet Mounting onto dosing station DTMaterial feed Mounting the suction pipe MVPipework Electrical connectionInstallation of the flap switch signal line Installation of the signal line of the SKW optionalInstallation of the alarm indicating device optional Installing the accessories Compressed-air supplyTechnical data SSE 5/BL Dimension Sheet Spare parts list SSE-f/BL, 230 V, 50 Hz SSE-5/BL, 230 V, 50 Hz Pos Order no Designation Wear CodeAccessories Accessories Electrical manual SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL SSE 5 BL