FRONT RIGGINGS | SECTION 7 |
Section 7 - Front Riggings - includes the following:
Removing/Installing/Adjusting Swingaway Footrest Assembly
Footplate Height Adjustment
Replacing Heel Loops
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.
REMOVING/INSTALLING/ADJUSTING SWINGAWAY FOOTREST ASSEMBLY (FIGURE 1)
FRONT RIGGINGS
REMOVING
1.Lift footrest assembly to disengage from shower commode chair frame.
2.Remove footrest assembly from chair frame.
INSTALLING
1.Place the top of the footrest assem- bly into Rehab Shower Commode chair frame.
2.Slide and push down to lock in place.
ADJUSTING
Footrest | Footrest | |
Footplate | ||
Assembly | ||
| ||
Rehab |
| |
Shower |
| |
Commode |
| |
Chair Frame |
| |
Footplate |
| |
Adjustment Pin |
|
FIGURE 1 - REMOVING/INSTALLING/
ADJUSTING SWINGAWAY
FOOTREST ASSEMBLY
1.Lift footrest assembly enough to disengage from inner pin, but not enough to totally remove from Rehab Shower Commode chair frame.
2.Swing the footrest to the outside of the Rehab Shower Commode chair.
3.Repeat the procedure for the other footrest assembly.
FOOTPLATE HEIGHT ADJUSTMENT
NOTE: Footplates adjust up and down by lifting up on the footplate until footplate adjustment pin disengages from hole.
1.Lift front of footplate up until footplate adjustment pin disengages from hole.
2.Slide footplate to alternate footplate adjustment height.
3.Push down on front of footplate until footplate adjustment pin engages into desired pin hole.
Part No. 1118394 | 23 | Rehab Shower Commode Chair |