HoMedics BPA-300 warranty Date & Time SET Procedure, Using the ARM Cuff

BPA-300-A.qxd 10/5/06 4:20 PM Page 13

DATE & TIME SET PROCEDURE

1.	To adjust the date/time, press the Set button			,
	located on the back of the monitor.
2.	The display will show a blinking number showing
	the hour. Change the hour by pressing the
	button. Each press will increase the number by one
	in a cycling manner. Press the Set button		again
	to confirm the entry, and the screen will show a blink-
	ing number representing the minutes.
3.	Change the time and date as described in Step 2
	above, using the	button to change the num-

USING THE ARM CUFF

Very Important: Proper cuff size is critical to accurate measurement.

This monitor comes with two sizes of arm cuffs: Standard Size Fits 9.5"–14.2" (24 cm – 36 cm) Large Size Fits 13.4"–18.1" (34 cm – 46 cm)

The appropriate cuff is suitable for your use if the colored arrow falls within the solid color line as shown below. If the Arrow falls outside of the Solid Color Line, you need a cuff with another circumference. For circumferences less than 9.5", contact HoMedics Consumer Relations.

Colored Arrow

bers and the Set button	to confirm the entries.
4. A “0” will reappear as the blood pressure monitor is
ready for measurement again.

Press the button

blinking hour

increasing hour

confirm the entry

F

A

L L

A N

D

S T

B

M

U

O

W

O W

L L

R R

Y

E

A

H

IN

W

IT

ARROW MUST FALL

WITHIN YELLOW BAND

Position cuff edge 0.6˝–1.0˝

(1.5–2.5cm) above elbow.

Standard

Size Cuff Fits:

	9.5–14.2 Inches
	24–36 Centimeters
Center tube over	Fit cuff securely. Allow room for
middle of arm.	two fingers to fit between the cuff
	and your arm.
	MODEL# PP-BPCUFF5
Center tube over
middle of arm

repeat process to set time and date

Solid Colored Line

13 14