A&D UA-1020CN Measurement with SET Pressure, Measurement with Desired Systolic Pressure

MEASUREMENT WITH SET PRESSURE

The UA-1020 is designed to detect the pulse and to inflate the cuff to a systolic pressure level automatically. If re-inflation occurs repeatedly, use the following methods.

During the blood pressure measurement, re-inflation may occur. A fixed pressure

value can be set to avoid re-inflation.

1.At step 6 of the clock adjustment procedure (see page E-10), press the SET button to go to the pressure setting mode. The current setting blinks.

2.Press the or button to select a pressure value about 30 mmHg or more above your expected systolic pressure from the following.

AUTO : Automatic pressurization (default value)

180: Pressure value of 180 mmHg (fixed)

210: Pressure value of 210 mmHg (fixed)

240: Pressure value of 240 mmHg (fixed)

3.Press the SET button to go to the TriCheck setting mode.

or

Turn off	TriCheck
	setting mode

Press the START button to turn the device off. After three minutes of non-operation, the device will turn off automatically. The next measurement will be performed with the new pressure value.

MEASUREMENT WITH DESIRED SYSTOLIC PRESSURE

Use this method when re-inflation occurs repeatedly even if the pressure value is set to 240 in the procedure above or when the results are not displayed even if the pressure decreases to 20 mmHg or less.

1.Place the cuff on the arm (preferably the left arm).

2.Press and hold the START button until a number about 30 to 40 mmHg higher than your expected systolic pressure appears.

3.When the desired number is reached, release the START button to start measurement. Continue to measure your blood pressure as described on the previous page.

At heart level

Press and hold the button

START

Release the button

at the desired

systolic pressure

Refer to previous page

for measurement

E-15 A&D Medical (Toll-Free): 1-888-726-9966