Invacare Pronto M51 Base manual Charging Batteries

Page 12

SECTION 1—GENERAL GUIDELINES

Batteries

The warranty and performance specifications contained in this manual are based on the use of deep cycle gel cell or sealed lead acid batteries. Invacare strongly recommends their use as the power source for this unit.

Carefully read battery/battery charger information prior to installing, servicing or operating your wheelchair.

Charging Batteries

DANGER

When using an extension cord, use only a three wire extension cord having at least 16 AWG (American Wire Gauge) wire and the same or higher electrical rating as the device being connected. Use of improper extension cord could result in risk of fire and electric shock. Three prong to two prong adapters should not be used. Use of three prong adapters can result in improper grounding and present a shock hazard to the user.

NEVER attempt to recharge the batteries by attaching cables directly to the battery terminals.

DO NOT attempt to recharge the batteries and operate the wheelchair at the same time.

DO NOT operate wheelchair with extension cord attached to the AC cable.

DO NOT attempt to recharge the batteries when the wheelchair has been exposed to any type of moisture.

DO NOT attempt to recharge the batteries when the wheelchair is outside.

DO NOT sit in the wheelchair while charging the batteries.

DO NOT attempt to recharge batteries using both the on‐board battery charger and an independent battery charger (plugged into the joystick charger port) at the same time. Doing so will reduce the life of the batteries.

Read and carefully follow the manufacturer’s instructions for each charger (supplied or purchased). If charging instructions are not supplied, consult a qualified technician for proper procedures.

Ensure the pins of the extension cord plug are the same number, size, and shape as those on the charger.

DO NOT under any circumstances cut or remove the round grounding plug from the charger AC cable plug or the extension cord plug.

Pronto® M51Base with SureStep®

12

Part No. 1148076

Image 12
Contents Pronto M51 Base with SureStep Reference Documents Reference DocumentsDocument Table of Contents Table of Contents Register Your ProductSpecial Notes Special NotesMeaning Trro and Trbkts Warnings Typical Product Parameters Typical Product ParametersLabel Location Label LocationWheelchairs With Trro Wheelchairs Without Trro Controller Settings/Repair or Service General GuidelinesOperation Information General GuidelinesAccessories Batteries Charging BatteriesWeight Training Weight LimitationGrounding Instructions Rain TestEMI Information EMI InformationEMI Information SAFETY/HANDLING of Wheelchairs SAFETY/HANDLING of WheelchairsStability and Balance Coping With Everyday Obstacles Coping With Everyday ObstaclesLifting/Stairways Lifting/Stairways Transferring To and From Other Seats Transferring To and From Other SeatsReaching, Leaning and Bending Forward Reaching and Bending BackwardSafety INSPECTION/ Troubleshooting Safety Inspection ChecklistsSafety INSPECTION/TROUBLESHOOTING Inspect/Adjust InitiallyTroubleshooting Guide Inspect/Adjust WeeklyInspect/Adjust Monthly Inspect/Adjust PeriodicallyGeneral Troubleshooting Symptom Probable Cause SolutionsInformation Gauge Display Diagnostics SPJ+ w/PSS or SPJ+ w/ACC JoysticksDisplay Description Definition Service Indicator Light Diagnostics Possible SolutionMPJ+, PSR+, PSF+ Joysticks or Displays BAD Joystick CAL Values Checking Battery Charge Level DON’TTurning the Power On/Off Wheelchair OperationOperating the Wheelchair Wheelchair OperationUsing the Joystick to Drive the Wheelchair Movement ActionOn/Off Button SpeedometerService Indicator Speed Control ButtonsJoystick Charger/Programming InputMPJ+ Joystick Switches and Indicators Drive Select Toggle SwitchSelecting the Drive Mode Information Gauge DisplaySpeed Control LCD Display ScreensSplash Screen Main ScreenStatus Indicator Wheelchair Operation DescriptionProgrammable Mono Port 1/2 or External Mode Switch Remote Stop SwitchRemote Mode Reset Switch Connected Devices ScreenRemote On/Off Switch Mode SwitchMemory Card Slot Repositioning Joystick JoystickDisconnecting/Connecting the Joysticks DisconnectingConnecting SPJ+ JoysticksTilting the Seat Assembly Formula CG Only Tilting the Seat Assembly BackSeat SeatTilting the Seat Assembly Forward Tilting the Seat Assembly Formula CG OnlyRemoving/Installing the Seat Assembly InstallingRemoving Footboard Assembly Removing/Installing the Footboard AssemblyFootboard Assembly Pinch point may occur when rotating the footboard assemblyAdjusting the Footboard Assembly AngleAdjusting the Footboard Assembly Angle DepthRemoving/Installing the Battery Shroud TOP Shroud and WheelsReplacing the Flat Free Tires on the Wheel Rim TOP Shroud and WheelsRemoving/Installing the Battery Shroud Engaging/Disengaging Motor Release Lever Engaging/Disengaging Motor Release LeverAdjusting Forks Replacing Front/Rear Caster AssembliesBatteries BatteriesUsing the Proper Batteries NegativeRemoving/Installing Batteries from/into Battery Tray Tool QTYRemoving/Installing Batteries from/into Battery Tray Connecting/Disconnecting Battery Cables Connecting Battery CablesCaps not shown on front When to Charge Batteries Disconnecting Battery CablesSPJ+ w/PSS and SPJ+ w/ACC Joysticks Charging Batteries MPJ+ JoystickBattery Charger Operation On-Board Battery ChargerON/OFF Indicator Charger Programming Port Transport Ready Package Transport Ready PackageSpecifications About Transport Ready PackagesCompliance Information Securing the Wheelchair to the Vehicle Positioning the Wheelchair in the VehicleSecurement Points Securing the WheelchairSecuring the Occupant Wheelchair-Anchored BeltsVehicle-Anchored Belts Seating SystemPositioning Belts Positioning BeltsPronto M51 Base with SureStep Pronto M51 Base with SureStep Pronto M51 Base with SureStep Limited Warranty USA