Invacare Pronto M51 Base Wheelchair Operation, Operating the Wheelchair, Turning the Power On/Off

Page 29

SECTION 5—WHEELCHAIR OPERATION

SECTION 5—WHEELCHAIR

OPERATION

WARNING

After ANY adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

Set-up of the Electronic Control Unit is to be performed only by a qualified techni- cian. The final adjustments of the controller may affect other activities of the wheel- chair. Damage to the equipment could occur under these circumstances.

Operating the Wheelchair

Turning the Power On/Off

NOTE: For this procedure, refer to FIGURE 5.1.

NOTE: MPJ+ Joystick available on Formula CG seating system only.

1. To turn the power On, perform one of the following steps:

JOYSTICK	ACTION

MPJ+	Move the On/Off switch Forward to the On position.

SPJ+	Press the On/Off button.

2. Turning the power Off can be achieved by performing one of the following steps:

JOYSTICK	ACTION

MPJ+	Move the On/Off switch Back to the Off position.

SPJ+	Press the On/Off button.

SPJ+ Joysticks

On/Off Button

MPJ+ Joystick (CG ONLY)

On/Off

Switch

FIGURE 5.1 Turning the Power On/Off

Part No. 1148076

29

Pronto® M51™ Base with SureStep®

Image 29

Contents Pronto M51 Base with SureStep Document Reference DocumentsReference Documents Table of Contents Register Your Product Table of ContentsMeaning Special NotesSpecial Notes Trro and Trbkts Warnings Typical Product Parameters Typical Product ParametersLabel Location Label LocationWheelchairs With Trro Wheelchairs Without Trro General Guidelines Controller Settings/Repair or ServiceOperation Information General GuidelinesAccessories Charging Batteries BatteriesWeight Limitation Weight TrainingGrounding Instructions Rain TestEMI Information EMI InformationEMI Information Stability and Balance SAFETY/HANDLING of WheelchairsSAFETY/HANDLING of Wheelchairs Coping With Everyday Obstacles Coping With Everyday ObstaclesLifting/Stairways Lifting/Stairways Transferring To and From Other Seats Transferring To and From Other SeatsReaching and Bending Backward Reaching, Leaning and Bending ForwardSafety Inspection Checklists Safety INSPECTION/ TroubleshootingSafety INSPECTION/TROUBLESHOOTING Inspect/Adjust InitiallyInspect/Adjust Weekly Troubleshooting GuideInspect/Adjust Monthly Inspect/Adjust PeriodicallySymptom Probable Cause Solutions General TroubleshootingDisplay Description Definition Information Gauge Display DiagnosticsSPJ+ w/PSS or SPJ+ w/ACC Joysticks MPJ+, PSR+, PSF+ Joysticks or Displays Service Indicator Light DiagnosticsPossible Solution BAD Joystick CAL Values DON’T Checking Battery Charge LevelWheelchair Operation Turning the Power On/OffOperating the Wheelchair Wheelchair OperationMovement Action Using the Joystick to Drive the WheelchairSpeedometer On/Off ButtonSpeed Control Buttons Service IndicatorJoystick Charger/Programming InputDrive Select Toggle Switch MPJ+ Joystick Switches and IndicatorsSelecting the Drive Mode Information Gauge DisplayLCD Display Screens Speed ControlMain Screen Splash ScreenWheelchair Operation Description Status IndicatorRemote Stop Switch Programmable Mono Port 1/2 or External Mode SwitchRemote Mode Reset Switch Connected Devices ScreenMemory Card Slot Remote On/Off SwitchMode Switch Joystick Repositioning JoystickDisconnecting Disconnecting/Connecting the JoysticksConnecting SPJ+ JoysticksTilting the Seat Assembly Back Tilting the Seat Assembly Formula CG OnlySeat SeatTilting the Seat Assembly Formula CG Only Tilting the Seat Assembly ForwardRemoving Removing/Installing the Seat AssemblyInstalling Removing/Installing the Footboard Assembly Footboard AssemblyFootboard Assembly Pinch point may occur when rotating the footboard assemblyAngle Adjusting the Footboard AssemblyDepth Adjusting the Footboard Assembly AngleTOP Shroud and Wheels Removing/Installing the Battery ShroudReplacing the Flat Free Tires on the Wheel Rim TOP Shroud and WheelsRemoving/Installing the Battery Shroud Engaging/Disengaging Motor Release Lever Engaging/Disengaging Motor Release LeverReplacing Front/Rear Caster Assemblies Adjusting ForksBatteries BatteriesNegative Using the Proper BatteriesTool QTY Removing/Installing Batteries from/into Battery TrayRemoving/Installing Batteries from/into Battery Tray Connecting Battery Cables Connecting/Disconnecting Battery CablesCaps not shown on front SPJ+ w/PSS and SPJ+ w/ACC Joysticks When to Charge BatteriesDisconnecting Battery Cables MPJ+ Joystick Charging BatteriesOn-Board Battery Charger Battery Charger OperationON/OFF Indicator Charger Programming Port Transport Ready Package Transport Ready PackageCompliance Information SpecificationsAbout Transport Ready Packages Positioning the Wheelchair in the Vehicle Securing the Wheelchair to the VehicleSecuring the Wheelchair Securement PointsWheelchair-Anchored Belts Securing the OccupantSeating System Vehicle-Anchored BeltsPositioning Belts Positioning BeltsPronto M51 Base with SureStep Pronto M51 Base with SureStep Pronto M51 Base with SureStep USA Limited Warranty