Invacare Pronto M51 Base Grounding Instructions, Rain Test, Weight Training, Weight Limitation

Page 13

SECTION 1—GENERAL GUIDELINES

Grounding Instructions

DO NOT, under any circumstances, cut or remove the round grounding prong from any plug used with or for Invacare products. Some devices are equipped with three‐prong (grounding) plugs for protection against possible shock hazards and fire. Where a two‐ prong wall receptacle is encountered, it is the personal responsibility and obligation of the customer to contact a qualified electrician and have the two‐prong receptacle replaced with a properly grounded three‐prong wall receptacle in accordance with the National Electrical Code. If you must use an extension cord, use only a three‐wire extension cord having the same or higher electrical rating as the device being connected. In addition, Invacare has placed RED/ORANGE warning tags on some equipment. DO NOT remove these tags.

Rain Test

Invacare has tested its power wheelchairs in accordance with ISO 7176 “Rain Test.” This provides the end user or his/her assistant sufficient time to remove his/her power wheelchair from a rain storm and retain wheelchair operation.

DO NOT leave power wheelchair in a rain storm of any kind.

DO NOT use power wheelchair in a shower.

DO NOT store power wheelchair in a damp area for an extended period of time.

Direct exposure to excessive rain or dampness may cause the chair to malfunction electrically and mechanically, may cause the chair to prematurely rust or may damage the upholstery.

Check to ensure that the RED and GREY battery terminal caps are secured in place, joystick boot is not torn or cracked where water can enter and that all electrical connections are secure at all times.

DO NOT use the wheelchair if the joystick boot is torn or cracked. If the joystick boot becomes torn or cracked, replace immediately.

Weight Training

Invacare does not recommend the use of its wheelchairs as a weight training apparatus. Invacare wheelchairs have not been designed or tested as a seat for any kind of weight training. If occupant uses said wheelchair as a weight training apparatus, Invacare shall not be liable for bodily injury and the warranty is void.

Weight Limitation

The wheelchair has a weight limitation of 300 lbs.

Part No. 1148076

13

Pronto® M51Base with SureStep®

Image 13
Contents Pronto M51 Base with SureStep Reference Documents Reference DocumentsDocument Table of Contents Register Your Product Table of ContentsSpecial Notes Special NotesMeaning Trro and Trbkts Warnings Typical Product Parameters Typical Product ParametersLabel Location Label LocationWheelchairs With Trro Wheelchairs Without Trro General Guidelines Controller Settings/Repair or ServiceOperation Information General GuidelinesAccessories Charging Batteries BatteriesWeight Limitation Weight TrainingGrounding Instructions Rain TestEMI Information EMI InformationEMI Information SAFETY/HANDLING of Wheelchairs SAFETY/HANDLING of WheelchairsStability and Balance Coping With Everyday Obstacles Coping With Everyday ObstaclesLifting/Stairways Lifting/Stairways Transferring To and From Other Seats Transferring To and From Other SeatsReaching and Bending Backward Reaching, Leaning and Bending ForwardSafety Inspection Checklists Safety INSPECTION/ TroubleshootingSafety INSPECTION/TROUBLESHOOTING Inspect/Adjust InitiallyInspect/Adjust Weekly Troubleshooting GuideInspect/Adjust Monthly Inspect/Adjust PeriodicallySymptom Probable Cause Solutions General TroubleshootingSPJ+ w/PSS or SPJ+ w/ACC Joysticks Information Gauge Display DiagnosticsDisplay Description Definition Possible Solution Service Indicator Light DiagnosticsMPJ+, PSR+, PSF+ Joysticks or Displays BAD Joystick CAL Values DON’T Checking Battery Charge LevelWheelchair Operation Turning the Power On/OffOperating the Wheelchair Wheelchair OperationMovement Action Using the Joystick to Drive the WheelchairSpeedometer On/Off ButtonSpeed Control Buttons Service IndicatorJoystick Charger/Programming InputDrive Select Toggle Switch MPJ+ Joystick Switches and IndicatorsSelecting the Drive Mode Information Gauge DisplayLCD Display Screens Speed ControlMain Screen Splash ScreenWheelchair Operation Description Status IndicatorRemote Stop Switch Programmable Mono Port 1/2 or External Mode SwitchRemote Mode Reset Switch Connected Devices ScreenMode Switch Remote On/Off SwitchMemory Card Slot Joystick Repositioning JoystickDisconnecting Disconnecting/Connecting the JoysticksConnecting SPJ+ JoysticksTilting the Seat Assembly Back Tilting the Seat Assembly Formula CG OnlySeat SeatTilting the Seat Assembly Formula CG Only Tilting the Seat Assembly ForwardInstalling Removing/Installing the Seat AssemblyRemoving Removing/Installing the Footboard Assembly Footboard AssemblyFootboard Assembly Pinch point may occur when rotating the footboard assemblyAngle Adjusting the Footboard AssemblyDepth Adjusting the Footboard Assembly AngleTOP Shroud and Wheels Removing/Installing the Battery ShroudReplacing the Flat Free Tires on the Wheel Rim TOP Shroud and WheelsRemoving/Installing the Battery Shroud Engaging/Disengaging Motor Release Lever Engaging/Disengaging Motor Release LeverReplacing Front/Rear Caster Assemblies Adjusting ForksBatteries BatteriesNegative Using the Proper BatteriesTool QTY Removing/Installing Batteries from/into Battery TrayRemoving/Installing Batteries from/into Battery Tray Connecting Battery Cables Connecting/Disconnecting Battery CablesCaps not shown on front Disconnecting Battery Cables When to Charge BatteriesSPJ+ w/PSS and SPJ+ w/ACC Joysticks MPJ+ Joystick Charging BatteriesOn-Board Battery Charger Battery Charger OperationON/OFF Indicator Charger Programming Port Transport Ready Package Transport Ready PackageAbout Transport Ready Packages SpecificationsCompliance Information Positioning the Wheelchair in the Vehicle Securing the Wheelchair to the VehicleSecuring the Wheelchair Securement PointsWheelchair-Anchored Belts Securing the OccupantSeating System Vehicle-Anchored BeltsPositioning Belts Positioning BeltsPronto M51 Base with SureStep Pronto M51 Base with SureStep Pronto M51 Base with SureStep USA Limited Warranty