Invacare Pronto M51 Base Programmable Mono Port 1/2 or External Mode Switch, Icon Description

SECTION 5—WHEELCHAIR OPERATION

Connected Devices Screen

NOTE: For this procedure, refer to FIGURE 5.8.

This screen is displayed if the Mode Select switch is held active for about 10 seconds. This screen shows an icon that represents any additional devices that are connected to the chair.

ICON	DESCRIPTION
	4-Switch Attendant Control
	RIM Control
	ECU (1 to 4)
	Proportional Attendant Control
	Compact Joystick
	Sip and Puff Control
	ASL Digital Control
	ASL Analog Control
	Shark Power Module Actuator

FIGURE 5.8 LCD Display Screens - Connected Devices Screen

Programmable Mono Port 1/2 or External Mode Switch

The programmable mono port or external mode switch input is located at the rear of the joystick on the left side. The programmable mono port input offers the choice of three options:

•Remote drive select

•Remote stop/mode (reset) input

•Single actuator input

The single switch functions operate through mono port 1. An optional y‐cable allows a second programmable function through mono port 2.

Remote Stop Switch

The remote stop switch is used to stop the wheelchair.

Remote Mode (Reset) Switch

The remote mode reset switch functions the same way as the mode switch. Refer to Mode Switch on page 38.

Part No. 1148076 37 Pronto® M51™ Base with SureStep®