Invacare Pronto M51 Base manual Checking Battery Charge Level, Don’T

Page 28

SECTION 4—SAFETY INSPECTION/TROUBLESHOOTING

Checking Battery Charge Level

The following “Do’s” and “Don’ts” are provided for your convenience and safety.

DON’T

DO

 

 

Don’t perform any installation or maintenance

Read and understand this manual and any service

without first reading this manual.

information that accompanies a battery and charger before

 

operating the wheelchair.

 

 

Don’t perform installation or maintenance of

Move the wheelchair to a work area before cleaning

batteries in an area that could be damaged by

terminals, or opening battery box.

battery spills.

 

 

 

Don’t make it a habit to discharge batteries to

Recharge as frequently as possible to maintain a high charge

the lowest level.

level and extend battery life.

 

 

Don’t use randomly chosen batteries or chargers.

Follow recommendations in this manual when selecting a

 

battery or charger.

 

 

Don’t put new batteries into service before

Fully charge a new battery before using.

charging.

 

 

 

Don’t tip or tilt batteries.

Use a carrying strap to remove, move or install a battery.

 

 

Don’t tap on clamps and terminals with tools.

Push battery clamps on the terminals. Spread clamps wider if

 

necessary.

 

 

Don’t mismatch your battery and chargers.

Use ONLY a GEL charger for a GEL battery.

 

 

Pronto® M51Base with SureStep®

28

Part No. 1148076

Image 28
Contents Pronto M51 Base with SureStep Reference Documents Reference DocumentsDocument Table of Contents Table of Contents Register Your ProductSpecial Notes Special NotesMeaning Trro and Trbkts Warnings Typical Product Parameters Typical Product ParametersLabel Location Label LocationWheelchairs With Trro Wheelchairs Without Trro Controller Settings/Repair or Service General GuidelinesOperation Information General GuidelinesAccessories Batteries Charging BatteriesWeight Training Weight LimitationGrounding Instructions Rain TestEMI Information EMI InformationEMI Information SAFETY/HANDLING of Wheelchairs SAFETY/HANDLING of WheelchairsStability and Balance Coping With Everyday Obstacles Coping With Everyday ObstaclesLifting/Stairways Lifting/Stairways Transferring To and From Other Seats Transferring To and From Other SeatsReaching, Leaning and Bending Forward Reaching and Bending BackwardSafety INSPECTION/ Troubleshooting Safety Inspection ChecklistsSafety INSPECTION/TROUBLESHOOTING Inspect/Adjust InitiallyTroubleshooting Guide Inspect/Adjust WeeklyInspect/Adjust Monthly Inspect/Adjust PeriodicallyGeneral Troubleshooting Symptom Probable Cause SolutionsSPJ+ w/PSS or SPJ+ w/ACC Joysticks Information Gauge Display DiagnosticsDisplay Description Definition Possible Solution Service Indicator Light DiagnosticsMPJ+, PSR+, PSF+ Joysticks or Displays BAD Joystick CAL Values Checking Battery Charge Level DON’TTurning the Power On/Off Wheelchair OperationOperating the Wheelchair Wheelchair OperationUsing the Joystick to Drive the Wheelchair Movement ActionOn/Off Button SpeedometerService Indicator Speed Control ButtonsJoystick Charger/Programming InputMPJ+ Joystick Switches and Indicators Drive Select Toggle SwitchSelecting the Drive Mode Information Gauge DisplaySpeed Control LCD Display ScreensSplash Screen Main ScreenStatus Indicator Wheelchair Operation DescriptionProgrammable Mono Port 1/2 or External Mode Switch Remote Stop SwitchRemote Mode Reset Switch Connected Devices ScreenMode Switch Remote On/Off SwitchMemory Card Slot Repositioning Joystick JoystickDisconnecting/Connecting the Joysticks DisconnectingConnecting SPJ+ JoysticksTilting the Seat Assembly Formula CG Only Tilting the Seat Assembly BackSeat SeatTilting the Seat Assembly Forward Tilting the Seat Assembly Formula CG OnlyInstalling Removing/Installing the Seat AssemblyRemoving Footboard Assembly Removing/Installing the Footboard AssemblyFootboard Assembly Pinch point may occur when rotating the footboard assemblyAdjusting the Footboard Assembly AngleAdjusting the Footboard Assembly Angle DepthRemoving/Installing the Battery Shroud TOP Shroud and WheelsReplacing the Flat Free Tires on the Wheel Rim TOP Shroud and WheelsRemoving/Installing the Battery Shroud Engaging/Disengaging Motor Release Lever Engaging/Disengaging Motor Release LeverAdjusting Forks Replacing Front/Rear Caster AssembliesBatteries BatteriesUsing the Proper Batteries NegativeRemoving/Installing Batteries from/into Battery Tray Tool QTYRemoving/Installing Batteries from/into Battery Tray Connecting/Disconnecting Battery Cables Connecting Battery CablesCaps not shown on front Disconnecting Battery Cables When to Charge BatteriesSPJ+ w/PSS and SPJ+ w/ACC Joysticks Charging Batteries MPJ+ JoystickBattery Charger Operation On-Board Battery ChargerON/OFF Indicator Charger Programming Port Transport Ready Package Transport Ready PackageAbout Transport Ready Packages SpecificationsCompliance Information Securing the Wheelchair to the Vehicle Positioning the Wheelchair in the VehicleSecurement Points Securing the WheelchairSecuring the Occupant Wheelchair-Anchored BeltsVehicle-Anchored Belts Seating SystemPositioning Belts Positioning BeltsPronto M51 Base with SureStep Pronto M51 Base with SureStep Pronto M51 Base with SureStep Limited Warranty USA