SECTION 10—TRANSPORT READY PACKAGE
Securing the Occupant
Wheelchair-Anchored Belts
WARNING
The pelvic belt that is provided by Invacare has been tested for use in a motor vehi- cle on this wheelchair ONLY. DO NOT replace the pelvic belt with a different style pelvic belt.
NOTE: For this procedure, refer to FIGURE 10.2.
The wheelchair has been provided with a pelvic belt which meets the requirements of ANSI/RESNA W/C 19.
The pelvic belt, provided by Invacare, has been designed to accommodate use on either side of the vehicle. If necessary, follow the instructions below to reverse the orientation of the pelvic belt to accommodate the vehicle‐anchored upper torso belt.
1.Install the pelvic belt pin (Detail ʺAʺ) into the large end of the slot in the belt mounting bracket. Rotate downward and forward until it snaps into place into the small end of the slot.
NOTE: Note the position of the male end of the belt when installing the pelvic belt onto the belt mounting brackets. The male end of the pelvic belt (Detail ʺAʺ) has a pin which is used to secure the vehicle‐anchored upper torso belt.
2.Repeat STEP 1 for the opposite belt mounting bracket.
3.Install the vehicle‐anchored upper torso belt onto the pin on the male end of the pelvic belt.
DETAIL “A”
Pin Pin
Pelvic Belt
Pin
(Used to secure the
vehicle anchored upper torso belt)
Back Angle
Bracket
Belt Mounting
Bracket
Large End
of Slot
Male End
Small End of Slot
FIGURE 10.2 Wheelchair-Anchored Belts
Pronto® M51™ Base with SureStep® | 66 | Part No. 1148076 |