Invacare Pronto M51 Base manual On/Off Button, Speedometer

Page 31

SECTION 5—WHEELCHAIR OPERATION

MK6i™ SPJ+ w/PSS and MK6i SPJ+ w/ACC Joystick Switches and Indicators

NOTE: For this procedure, refer to FIGURE 5.3.

 

 

Joystick

 

Information

 

 

Gauge Display

 

On/Off

Mode Button*

 

Button

 

Decrease

Speedometer

Not

Speed Button

 

(Tortoise)

Increase

Active

 

Speed Button

Additional Input

GREEN

(Hare)

for Powered

 

LED

 

 

Seating Switch

 

 

Service Indicator

*NOTE: The mode button is only present on SPJ+ w/ACC joystick.

DETAIL “A” -

FRONT VIEW

Charger/

Programming

Input

FIGURE 5.3 MK6i™ SPJ+ w/PSS and MK6i SPJ+ w/ACC Joystick Switches and Indicators

On/Off Button

This button is located at the front of the joystick housing. It is used to turn the wheelchair On and Off, to remove the joystick from sleep mode (if programmed) and to lock or unlock the joystick (if programmed).

Speedometer

The speedometer is used to show the maximum speed. The right‐most LED indicates current maximum speed setting. The bottom left GREEN LED flashes to indicate that the joystick is in speed limit mode. Speed limit mode limits the drive speed to a pre‐ programmed value, typically when the seat has been elevated and the wheelchair is required to drive at 20% speed.

Part No. 1148076

31

Pronto® M51Base with SureStep®

Image 31
Contents Pronto M51 Base with SureStep Reference Documents Reference DocumentsDocument Table of Contents Register Your Product Table of ContentsSpecial Notes Special NotesMeaning Trro and Trbkts Warnings Typical Product Parameters Typical Product ParametersLabel Location Label LocationWheelchairs With Trro Wheelchairs Without Trro General Guidelines Controller Settings/Repair or ServiceGeneral Guidelines Operation InformationAccessories Charging Batteries BatteriesRain Test Weight TrainingWeight Limitation Grounding InstructionsEMI Information EMI InformationEMI Information SAFETY/HANDLING of Wheelchairs SAFETY/HANDLING of WheelchairsStability and Balance Coping With Everyday Obstacles Coping With Everyday ObstaclesLifting/Stairways Lifting/Stairways Transferring To and From Other Seats Transferring To and From Other SeatsReaching and Bending Backward Reaching, Leaning and Bending ForwardInspect/Adjust Initially Safety INSPECTION/ TroubleshootingSafety Inspection Checklists Safety INSPECTION/TROUBLESHOOTINGInspect/Adjust Periodically Troubleshooting GuideInspect/Adjust Weekly Inspect/Adjust MonthlySymptom Probable Cause Solutions General TroubleshootingSPJ+ w/PSS or SPJ+ w/ACC Joysticks Information Gauge Display DiagnosticsDisplay Description Definition Possible Solution Service Indicator Light DiagnosticsMPJ+, PSR+, PSF+ Joysticks or Displays BAD Joystick CAL Values DON’T Checking Battery Charge LevelWheelchair Operation Turning the Power On/OffWheelchair Operation Operating the WheelchairMovement Action Using the Joystick to Drive the WheelchairSpeedometer On/Off ButtonCharger/Programming Input Service IndicatorSpeed Control Buttons JoystickInformation Gauge Display MPJ+ Joystick Switches and IndicatorsDrive Select Toggle Switch Selecting the Drive ModeLCD Display Screens Speed ControlMain Screen Splash ScreenWheelchair Operation Description Status IndicatorConnected Devices Screen Programmable Mono Port 1/2 or External Mode SwitchRemote Stop Switch Remote Mode Reset SwitchMode Switch Remote On/Off SwitchMemory Card Slot Joystick Repositioning JoystickSPJ+ Joysticks Disconnecting/Connecting the JoysticksDisconnecting ConnectingSeat Tilting the Seat Assembly Formula CG OnlyTilting the Seat Assembly Back SeatTilting the Seat Assembly Formula CG Only Tilting the Seat Assembly ForwardInstalling Removing/Installing the Seat AssemblyRemoving Pinch point may occur when rotating the footboard assembly Footboard AssemblyRemoving/Installing the Footboard Assembly Footboard AssemblyAngle Adjusting the Footboard AssemblyDepth Adjusting the Footboard Assembly AngleTOP Shroud and Wheels Removing/Installing the Battery ShroudTOP Shroud and Wheels Replacing the Flat Free Tires on the Wheel RimRemoving/Installing the Battery Shroud Engaging/Disengaging Motor Release Lever Engaging/Disengaging Motor Release LeverReplacing Front/Rear Caster Assemblies Adjusting ForksBatteries BatteriesNegative Using the Proper BatteriesTool QTY Removing/Installing Batteries from/into Battery TrayRemoving/Installing Batteries from/into Battery Tray Connecting Battery Cables Connecting/Disconnecting Battery CablesCaps not shown on front Disconnecting Battery Cables When to Charge BatteriesSPJ+ w/PSS and SPJ+ w/ACC Joysticks MPJ+ Joystick Charging BatteriesOn-Board Battery Charger Battery Charger OperationON/OFF Indicator Charger Programming Port Transport Ready Package Transport Ready PackageAbout Transport Ready Packages SpecificationsCompliance Information Positioning the Wheelchair in the Vehicle Securing the Wheelchair to the VehicleSecuring the Wheelchair Securement PointsWheelchair-Anchored Belts Securing the OccupantSeating System Vehicle-Anchored BeltsPositioning Belts Positioning BeltsPronto M51 Base with SureStep Pronto M51 Base with SureStep Pronto M51 Base with SureStep USA Limited Warranty