Invacare Pronto M51 Base manual Removing/Installing Batteries from/into Battery Tray

Page 54

SECTION 9—BATTERIES

2.Position the front battery in the front of the battery tray.

3.Position rear battery in rear of battery tray.

NOTE: Ensure that both batteries are properly seated and resting on the battery tray.

4.Connect the rear battery to the front battery (RED and BLACK connectors).

5.Connect the front battery to the controller (BLACK connector).

6.Reinstall the top shroud. Refer to Removing/Installing the Top Shroud on page 85.

7.Perform one of the following:

Lower the seat assembly to the up position. Refer to Tilting the Seat Assembly (Formula CG Only) on page 41.

Install the seat assembly from the wheelchair. Refer to Removing/Installing the Seat Assembly on page 43.

8.Lower the seat assembly to the down position. Refer to Tilting the Seat Assembly (Formula CG Only) on page 41.

9.Remove the battery shroud. Refer to Removing/Installing the Battery Shroud on page 47.

10.Connect joystick cable (not shown). Refer to Disconnecting/Connecting the Joystick on page 121.

Battery Handle

Battery Shroud

 

BLACK Battery

RED Battery Connectors

Connectors

BLACK Controller

 

Rear Battery

Connector

Joystick

Plug into Controller

 

Cable

 

 

Front Battery

Rear of

 

Wheelchair

Front of

 

 

Wheelchair

Wheelchair

 

Base Frame

 

FIGURE 9.2 Removing/Installing Batteries from/into Battery Tray

Pronto® M51Base with SureStep®

54

Part No. 1148076

Image 54
Contents Pronto M51 Base with SureStep Reference Documents Reference DocumentsDocument Table of Contents Table of Contents Register Your ProductSpecial Notes Special NotesMeaning Trro and Trbkts Warnings Typical Product Parameters Typical Product ParametersLabel Location Label LocationWheelchairs With Trro Wheelchairs Without Trro Operation Information Controller Settings/Repair or ServiceGeneral Guidelines General GuidelinesAccessories Batteries Charging BatteriesGrounding Instructions Weight TrainingWeight Limitation Rain TestEMI Information EMI InformationEMI Information SAFETY/HANDLING of Wheelchairs SAFETY/HANDLING of WheelchairsStability and Balance Coping With Everyday Obstacles Coping With Everyday ObstaclesLifting/Stairways Lifting/Stairways Transferring To and From Other Seats Transferring To and From Other SeatsReaching, Leaning and Bending Forward Reaching and Bending BackwardSafety INSPECTION/TROUBLESHOOTING Safety INSPECTION/ TroubleshootingSafety Inspection Checklists Inspect/Adjust InitiallyInspect/Adjust Monthly Troubleshooting GuideInspect/Adjust Weekly Inspect/Adjust PeriodicallyGeneral Troubleshooting Symptom Probable Cause SolutionsInformation Gauge Display Diagnostics SPJ+ w/PSS or SPJ+ w/ACC JoysticksDisplay Description Definition Service Indicator Light Diagnostics Possible SolutionMPJ+, PSR+, PSF+ Joysticks or Displays BAD Joystick CAL Values Checking Battery Charge Level DON’TOperating the Wheelchair Turning the Power On/OffWheelchair Operation Wheelchair OperationUsing the Joystick to Drive the Wheelchair Movement ActionOn/Off Button SpeedometerJoystick Service IndicatorSpeed Control Buttons Charger/Programming InputSelecting the Drive Mode MPJ+ Joystick Switches and IndicatorsDrive Select Toggle Switch Information Gauge DisplaySpeed Control LCD Display ScreensSplash Screen Main ScreenStatus Indicator Wheelchair Operation DescriptionRemote Mode Reset Switch Programmable Mono Port 1/2 or External Mode SwitchRemote Stop Switch Connected Devices ScreenRemote On/Off Switch Mode SwitchMemory Card Slot Repositioning Joystick JoystickConnecting Disconnecting/Connecting the JoysticksDisconnecting SPJ+ JoysticksSeat Tilting the Seat Assembly Formula CG OnlyTilting the Seat Assembly Back SeatTilting the Seat Assembly Forward Tilting the Seat Assembly Formula CG OnlyRemoving/Installing the Seat Assembly InstallingRemoving Footboard Assembly Footboard AssemblyRemoving/Installing the Footboard Assembly Pinch point may occur when rotating the footboard assemblyAdjusting the Footboard Assembly AngleAdjusting the Footboard Assembly Angle DepthReplacing the Flat Free Tires on the Wheel Rim Removing/Installing the Battery ShroudTOP Shroud and Wheels TOP Shroud and WheelsRemoving/Installing the Battery Shroud Engaging/Disengaging Motor Release Lever Engaging/Disengaging Motor Release LeverAdjusting Forks Replacing Front/Rear Caster AssembliesBatteries BatteriesUsing the Proper Batteries NegativeRemoving/Installing Batteries from/into Battery Tray Tool QTYRemoving/Installing Batteries from/into Battery Tray Connecting/Disconnecting Battery Cables Connecting Battery CablesCaps not shown on front When to Charge Batteries Disconnecting Battery CablesSPJ+ w/PSS and SPJ+ w/ACC Joysticks Charging Batteries MPJ+ JoystickBattery Charger Operation On-Board Battery ChargerON/OFF Indicator Charger Programming Port Transport Ready Package Transport Ready PackageSpecifications About Transport Ready PackagesCompliance Information Securing the Wheelchair to the Vehicle Positioning the Wheelchair in the VehicleSecurement Points Securing the WheelchairSecuring the Occupant Wheelchair-Anchored BeltsVehicle-Anchored Belts Seating SystemPositioning Belts Positioning BeltsPronto M51 Base with SureStep Pronto M51 Base with SureStep Pronto M51 Base with SureStep Limited Warranty USA