Invacare Pronto M51 Base manual Charger Programming Port

SECTION 9—BATTERIES

Charging Using An Independent Charger Plugged Into The Joystick

WARNING

Read and carefully follow the individual instructions for each charger (supplied or purchased). If charging instructions are not supplied, consult a qualified technician for proper procedures.

DO NOT attempt to recharge the batteries using both the on-board battery charger and an independent battery charger (plugged into the joystick charger port) at the same time. Doing so will reduce the life of the batteries.

CAUTION

Only use a charger approved by Invacare when charging through the joystick on this wheelchair model.

DO NOT use an independent charger with an output rating of over 8A (Amps). Otherwise, damage may occur.

NOTE: For this procedure, refer to FIGURE 9.7.

NOTE: The charger port located on the front of the joystick requires the use of an independent charger. The independent charger is NOT supplied with the wheelchair.

1.Attach the battery charger connector to the charger port on the front of the joystick.

2.Plug the charger’s AC power cord or extension into the grounded 110‐volt wall outlet.

3.When charging is complete, turn charger Off.

4.Disconnect output cable from joystick charger port.

SPJ+ Joysticks

Charger/

Programming

Port

MPJ+ Joystick

Charger/Programming Port (On

Front of Joystick)

FIGURE 9.7 Charging Using An Independent Charger Plugged Into The Joystick

Part No. 1148076 61 Pronto® M51™ Base with SureStep®