Invacare Pronto M51 Base manual Securing the Wheelchair to the Vehicle

Page 64

SECTION 10—TRANSPORT READY PACKAGE

Securing the Wheelchair to the Vehicle

Positioning the Wheelchair in the Vehicle

WARNING

This wheelchair must be in a forward facing position during travel in a motor vehicle.

The recommended clear zones for wheelchair seated occupants restrained by BOTH pelvic and upper-torso belt(s) and ONLY by a pelvic belt are shown in the diagrams and described below.

Frontal Clear Zones (FCZ) need to be LARGER when upper-torso belt(s) are NOT used.

The rear clear zone of 16-inches is measured from the rearmost point on an occupant’s head.

The frontal clear zone is measured from the frontmost point on an occupant’s head and is 26-inches with pelvic and upper-torso belt(s) and 37-inches with ONLY a pelvic belt.

The frontal clear zone may not be achievable for wheelchair-seated drivers.

 

Side View

 

Frontal Clear

 

Zone

16 in.

 

HHT

Top View

The estimated seated height (HHT) from the ground or floor to the top of the wheelchair-seated occupant’s head ranges from approximately 47-inches for a small adult female to about 61- inches for a tall adult male.

8in.

8 in.

16 in.

FCZ

Frontal Clear

Zone

Pronto® M51Base with SureStep®

64

Part No. 1148076

Image 64
Contents Pronto M51 Base with SureStep Reference Documents Reference DocumentsDocument Table of Contents Table of Contents Register Your ProductSpecial Notes Special NotesMeaning Trro and Trbkts Warnings Typical Product Parameters Typical Product ParametersLabel Location Label LocationWheelchairs With Trro Wheelchairs Without Trro Controller Settings/Repair or Service General GuidelinesOperation Information General GuidelinesAccessories Batteries Charging BatteriesWeight Training Weight LimitationGrounding Instructions Rain TestEMI Information EMI InformationEMI Information SAFETY/HANDLING of Wheelchairs SAFETY/HANDLING of WheelchairsStability and Balance Coping With Everyday Obstacles Coping With Everyday ObstaclesLifting/Stairways Lifting/Stairways Transferring To and From Other Seats Transferring To and From Other SeatsReaching, Leaning and Bending Forward Reaching and Bending BackwardSafety INSPECTION/ Troubleshooting Safety Inspection ChecklistsSafety INSPECTION/TROUBLESHOOTING Inspect/Adjust InitiallyTroubleshooting Guide Inspect/Adjust WeeklyInspect/Adjust Monthly Inspect/Adjust PeriodicallyGeneral Troubleshooting Symptom Probable Cause SolutionsSPJ+ w/PSS or SPJ+ w/ACC Joysticks Information Gauge Display DiagnosticsDisplay Description Definition Possible Solution Service Indicator Light DiagnosticsMPJ+, PSR+, PSF+ Joysticks or Displays BAD Joystick CAL Values Checking Battery Charge Level DON’TTurning the Power On/Off Wheelchair OperationOperating the Wheelchair Wheelchair OperationUsing the Joystick to Drive the Wheelchair Movement ActionOn/Off Button SpeedometerService Indicator Speed Control ButtonsJoystick Charger/Programming InputMPJ+ Joystick Switches and Indicators Drive Select Toggle SwitchSelecting the Drive Mode Information Gauge DisplaySpeed Control LCD Display ScreensSplash Screen Main ScreenStatus Indicator Wheelchair Operation DescriptionProgrammable Mono Port 1/2 or External Mode Switch Remote Stop SwitchRemote Mode Reset Switch Connected Devices ScreenMode Switch Remote On/Off SwitchMemory Card Slot Repositioning Joystick JoystickDisconnecting/Connecting the Joysticks DisconnectingConnecting SPJ+ JoysticksTilting the Seat Assembly Formula CG Only Tilting the Seat Assembly BackSeat SeatTilting the Seat Assembly Forward Tilting the Seat Assembly Formula CG OnlyInstalling Removing/Installing the Seat AssemblyRemoving Footboard Assembly Removing/Installing the Footboard AssemblyFootboard Assembly Pinch point may occur when rotating the footboard assemblyAdjusting the Footboard Assembly AngleAdjusting the Footboard Assembly Angle DepthRemoving/Installing the Battery Shroud TOP Shroud and WheelsReplacing the Flat Free Tires on the Wheel Rim TOP Shroud and WheelsRemoving/Installing the Battery Shroud Engaging/Disengaging Motor Release Lever Engaging/Disengaging Motor Release LeverAdjusting Forks Replacing Front/Rear Caster AssembliesBatteries BatteriesUsing the Proper Batteries NegativeRemoving/Installing Batteries from/into Battery Tray Tool QTYRemoving/Installing Batteries from/into Battery Tray Connecting/Disconnecting Battery Cables Connecting Battery CablesCaps not shown on front Disconnecting Battery Cables When to Charge BatteriesSPJ+ w/PSS and SPJ+ w/ACC Joysticks Charging Batteries MPJ+ JoystickBattery Charger Operation On-Board Battery ChargerON/OFF Indicator Charger Programming Port Transport Ready Package Transport Ready PackageAbout Transport Ready Packages SpecificationsCompliance Information Securing the Wheelchair to the Vehicle Positioning the Wheelchair in the VehicleSecurement Points Securing the WheelchairSecuring the Occupant Wheelchair-Anchored BeltsVehicle-Anchored Belts Seating SystemPositioning Belts Positioning BeltsPronto M51 Base with SureStep Pronto M51 Base with SureStep Pronto M51 Base with SureStep Limited Warranty USA