Start Treatment
1Make sure the power is on.
A welcome message is displayed briefly on the LCD screen, then the standby (Ramp) screen appears. The key and LCD backlights also turn on.
2Lie down and arrange the air tubing so that it is free to move if you turn in your sleep.
CAUTION
! • Do not leave long lengths of air tubing around the top of your bed. They could twist around your head or neck while you are sleeping.
• Make sure the area around the flow generator is dry and clean. It should also be clear of bedding, clothes and other potential blockages.
3Alter the ramp time if required (see “How to Change the Ramp Time” on page 13).
To start treatment, press the Start/Stop key, unless your clinician has set up your device to start delivering therapy automatically. If so, your device will start when you breathe into your mask (see “SmartStart” for details).
4Fit your mask as described in the mask user instructions.
WARNING
! A mask should not be used unless the S8 Elite II device is powered and operating properly.
5When ramping begins, the LCD will display the word "RAMPING", with the current pressure indicated as dashes. Each dash is approximately equivalent to
2 cm H2O. For example, 6 dashes represents approximately 12 cm H2O pressure.
SmartStart™
The S8 Elite II has a function called SmartStart™ that your clinician can enable. If SmartStart is enabled, your device will start automatically when you breathe into your mask, and will stop automatically when you take your mask off. This means you do not have to press the Start/Stop key to begin or end treatment.
Note: Do not use SmartStart when using a mask with an
Stopping Treatment
To stop treatment at any time, remove your mask and press the Start/Stop key or
if your clinician has enabled SmartStart, simply remove your mask and treatment will end.
How to Use the S8 Elite II | 8 |