ResMed 338425/1 manual R001-307/1

Page 40

Guidance and Manufacturer’s Declaration — Electromagnetic Emissions and Immunity

Guidance and manufacturer’s declaration—electromagnetic emissions

The S8 series of devices is intended for use in the electromagnetic environment specified below. The customer or the user of the S8 device should assure that the device is used in such an environment.

Emissions test

Compliance

Electromagnetic

environment—guidance

 

 

 

 

 

RF emissions CISPR 11

Group 1

The S8 device uses RF energy only for

 

 

its internal function. Therefore, its RF

 

 

emissions are very low and are not

 

 

likely to cause any interference in

 

 

nearby electronic equipment.

 

 

 

RF emissions CISPR 11 with

Class B*

The S8 device is suitable for use in all

serial adapter

 

establishments, including domestic

 

 

establishments and those directly

 

 

RF emissions CISPR 11 with

Class B

connected to the public low-voltage

USB adapter

 

network that supplies buildings used

 

 

for domestic purposes.

Harmonic Emissions

Class A

 

IEC 61000-3-2

 

 

 

 

 

Voltage Fluctuations/Flicker

Complies

 

Emissions IEC 61000-3-3

 

 

 

 

 

*Class B for all system configurations except when a PC is attached to the S8 device via a serial adapter, in which case the system is Class A compliant. Class A is suitable for use in all establishments other than domestic and those directly connected to a low voltage power supply network which supplies buildings used for domestic purposes.

Medical Electrical Equipment needs special precautions regarding EMC and needs to be installed and put into service according to EMC information provided in this document.

Warnings: The S8 device should not be used adjacent to or stacked with other equipment. If adjacent or stacked use is necessary, the S8 device should be observed to verify normal operation in the configuration in which it will be used.

The use of accessories (eg humidifiers) other than those specified in this manual is not recommended. They may result in increased emissions or decreased immunity of the S8 device.

R001-307/1 05

System Specifications

34

Image 40
Contents S8 Elite II System Page S8 Elite II System Blank Module Contents Replacing the Air Filter Servicing Introduction Your ResponsibilityAbout the S8 Elite Medical InformationContraindications Page Adverse Effects S8 Elite S8 Elite II SystemMasks Humidifier AccessoriesResScan Data Card Module Set Up the S8 Elite How to Use the S8 EliteAssemble the Mask Stopping Treatment Start TreatmentSmartStart Excelnt Page Attach a HumidAire 3i Humidifier How to Attach a HumidifierStoring the HumidAire LCD Screen How to use the KeypadKeypad Keys How to Change the Settings How to Change the Ramp TimeHow to Change the Expiratory Pressure Relief Setting How to Use the Standard MenuHow to Select the Mask Type Other viewable information How to Use the Detailed Menu Shows the detailed menuSettings Menu How to Change the Tube LengthHow to Add a Humidifier or Front Cap How to Change the SmartStart SettingResults Menu Options MenuServicing Menu Messages on the S8 Elite II LCDReplace Using a ResScan Data Card Module Using a Blank ModuleS8 Modules Using the Data Card to Update Settings Page Cleaning and Maintenance Daily CleaningWeekly Cleaning Periodic CleaningReplacing the Air Filter ServicingFrequently Asked Questions Can I use my S8 Elite II if mains AC power is not available? Troubleshooting No displaySystem ERR nnnn Leak Settings Success Remove Card System Specifications S8 Elite II no AccessoriesData Card All Devices where applicableData Card Module Symbols which appear on the device R001-307/1 System Specifications Portable and mobile RF communications Separation distance according to frequency of transmitter Limited Warranty Index PCB