Ericsson LBI-38377E manual TX Transmitter enabled On when the radio is transmitting

Page 14

T99 Type 99 tone decode - On indicates Type 99 tone decoding is enabled on the se- lected channel. Flashing indicates a T99 selective call has been received and the radio must be reset to receive another T99 call.

TX Transmitter enabled - On when the radio is transmitting.

BSY BuSY - On indicates a carrier is being received (the channel is busy). Note that if the selected channel is programmed for Channel Guard (CG), Digital Channel Guard (DCG), or Type 99 (T99) tone de- code operation, the radio will not un- squelch if a valid tone or code is not received; the BSY status flag will be on.

CG Channel Guard - On indicates tone Chan- nel Guard (CG) or Digital Channel Guard (DCG) encode/decode is enabled on the selected channel.

BAT BATtery low - On indicates the battery pack’s charge is low.

The following status flags are for use with Scan and System model radios:

SScan list - On indicates the selected chan- nel is on the scan list.

1priority 1 - On indicates the selected chan- nel is designated as the priority-one scan channel.

2priority 2 - On indicates the selected chan- nel is designated as the priority-two scan channel.

SCN SCaN mode - On indicates the radio is scanning.

UNIVERSAL DEVICE CONNECTOR

The Universal Device Connector (UDC) is lo- cated on the side of the radio just above the PTT and MONITOR BUTTONS. This connector provides con- nections for the external accessories such as a head- set, a speaker-mike, or an emergency lanyard. When the radio is locked in a vehicular charger/repeater the UDC provides the audio and control connections between the radio and the vehicular charger/re- peater. The UDC is also used by the maintenance personnel when the radio is programmed.

14

Image 14

Contents Operator’s Manual Ericsson Inc Table of Contents Safety Not Applicable TTDIntroduction Controls ON/OFF SwitchVolume Control Knob Control KnobEmergency Button PTT ButtonMonitor Button PA Personal Radio Side View Front View Menu Display Alert Allows the alert tones to be dis- abled or enabledMenu Button Scan Model KEY Lock Allows the keypad buttons to be locked or unlockedChannel Exit ButtonScan Button ModePA System Model Radio Select Button Indicators Dtmf KeypadTX Transmitter enabled On when the radio is transmitting Universal Device ConnectorAlert Tones Carrier Control TimerOperation POWER-UP Channel BusyPress the Menu button until Channel appears in the display Press the Menu button until Mode ap- pears in the displayMODE/CHANNEL/CG Selection Adjust the volume as necessary Receiving a MessageTransmitting a Message Listen for a replyAdding Channels To And Deleting Channels From The Scan List Press the Menu button until Scan A/D is displayedTelephone Interconnect Calls Using ScanScan DIS - The radio is not programmed to scan Scan ModelIf the SCN status flag is on, press Scan to turn scan off Press the Menu button until Phone ap- pears in the displayPress and hold the PTT Button to key the transmitter Telephone Interconnect Calls System ModelsPlacing a Manually Dialed Call Release the PTT Button and listen for a dial tone Release the PTT Button when the dial sequence is completeWhile holding the PTT BUTTON, press Placing An Automatically Dialed CallLock The Keypad KEY Lock Menu Scan and System modelsProgrammable Features Disable The Alert TonesEnable The Alert Tones Unlock The KeypadProgrammable by Channel Radio ProgrammableWhen using your two-way radio, remember these rules Operating TipsBattery Packs Installing the Battery Pack Installing the Battery Pack Removing the Battery PackSwivel Mount Removal Replacement Contains a rechargeable, recyclablePacity Short Case Intrinsically Safe UsageBatteries Accessories Warranty NICKEL-CADMIUM Battery Warranty Warranty becomes void ifPage Emergency Numbers