Ericsson LBI-38377E manual Programmable by Channel, Radio Programmable

Page 26

PROGRAMMABLE BY CHANNEL

∙Transmit and Receive Frequencies

∙8-Character Alphanumeric Display (Channel Designator)

∙Tone or Digital Channel Guard Encode/De- code

∙Type 99 Tone Decode

∙Transmit Power Level High or Low

∙Transmit STE On or Off

∙Channel Busy Lockout

∙Carrier Control Timer

∙Backlight On or Off

∙Alert Tones On of Off

∙Switch Crystal Frequency

∙GE-STAR

∙GE-STAR sent with Channel Guard

∙Channel Scan (Scan or System Radio)

RADIO PROGRAMMABLE

∙Minimum Volume Level

∙GE-STAR Lanyard

∙Emergency Channel

∙Vehicular Charger Backlight

∙Control Knob Selects Channels, Modes or Channel Guard

∙Mode Control (Scan or System Radio)

∙Menu Selections (Scan or System Radio)

∙Home Mode or Home Channel (Depending on Control Knob Programming (Scan or Sys- tem Radio)

∙Scan Enabled or Disabled (Scan or System Radio)

∙Priority-One and Priority-Two Scan Channel (Scan or System Radio)

∙Selected Channel is Priority-One Scan Channel (Scan or System Radio)

∙DTMF Enabled Per Mode (Scan or System Radio)

∙Ten (10) Telephone Numbers (Scan or Sys- tem Radio)

26

Image 26

Contents Operator’s Manual Ericsson Inc Table of Contents Safety Not Applicable TTDIntroduction Controls ON/OFF SwitchVolume Control Knob Control KnobEmergency Button PTT ButtonMonitor Button PA Personal Radio Side View Front View Menu Display Alert Allows the alert tones to be dis- abled or enabledMenu Button Scan Model KEY Lock Allows the keypad buttons to be locked or unlockedChannel Exit ButtonScan Button ModePA System Model Radio Select Button Indicators Dtmf KeypadTX Transmitter enabled On when the radio is transmitting Universal Device ConnectorAlert Tones Carrier Control TimerOperation POWER-UP Channel BusyPress the Menu button until Channel appears in the display Press the Menu button until Mode ap- pears in the displayMODE/CHANNEL/CG Selection Adjust the volume as necessary Receiving a MessageTransmitting a Message Listen for a replyAdding Channels To And Deleting Channels From The Scan List Press the Menu button until Scan A/D is displayedTelephone Interconnect Calls Using ScanScan DIS - The radio is not programmed to scan Scan ModelIf the SCN status flag is on, press Scan to turn scan off Press the Menu button until Phone ap- pears in the displayPress and hold the PTT Button to key the transmitter Telephone Interconnect Calls System ModelsPlacing a Manually Dialed Call Release the PTT Button and listen for a dial tone Release the PTT Button when the dial sequence is completeWhile holding the PTT BUTTON, press Placing An Automatically Dialed CallLock The Keypad KEY Lock Menu Scan and System modelsProgrammable Features Disable The Alert TonesEnable The Alert Tones Unlock The KeypadProgrammable by Channel Radio ProgrammableWhen using your two-way radio, remember these rules Operating TipsBattery Packs Installing the Battery Pack Installing the Battery Pack Removing the Battery PackSwivel Mount Removal Replacement Contains a rechargeable, recyclablePacity Short Case Intrinsically Safe UsageBatteries Accessories Warranty NICKEL-CADMIUM Battery Warranty Warranty becomes void ifPage Emergency Numbers