Ericsson LBI-38377E manual Intrinsically Safe Usage, Batteries, Pacity Short Case

Page 31

Figure 10 - Swivel Mount Removal and Replacement

INTRINSICALLY SAFE USAGE

Selected portable radios with appropriate factory installed F4 Options are certified as Intrinsically Safe by the Factory Mutual Research Corporation. Intrin- sically Safe approval includes Class I, II, III, Division 1 hazardous locations in the presence of Groups C,

D, E, F and G atmospheres. Non-Incendive approval includes Class I, Division 2 hazardous locations in the presence of Groups A, B, C, and D atmospheres.

Hazardous locations are defined in the National Electrical Code. Useful standards NFPA 437A and NFPA 437M for the classifications of hazardous areas may be ordered from the National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.

BATTERIES

Only batteries identified with a green latch shall be used with a portable radio that is rated and labeled as Factory Mutual Intrinsically Safe. Use of nonspe- cified batteries voids Factory Mutual approval. The following battery pack options are approved for use in intrinsically safe radios:

∙ PAPA1F Rechargeable Battery, Extra High Capacity (Tall Case)

∙ PAPA1G	Rechargeable Battery, High Ca-
	pacity (Short Case)

31

Image 31

Contents Operator’s Manual Ericsson Inc Table of Contents TTD Safety Not ApplicableControl Knob Controls ON/OFF SwitchVolume Control Knob IntroductionMonitor Button PTT ButtonEmergency Button PA Personal Radio Side View Front View KEY Lock Allows the keypad buttons to be locked or unlocked Alert Allows the alert tones to be dis- abled or enabledMenu Button Scan Model Menu DisplayMode Exit ButtonScan Button ChannelPA System Model Radio Select Button Dtmf Keypad IndicatorsUniversal Device Connector TX Transmitter enabled On when the radio is transmittingChannel Busy Carrier Control TimerOperation POWER-UP Alert TonesMODE/CHANNEL/CG Selection Press the Menu button until Mode ap- pears in the displayPress the Menu button until Channel appears in the display Receiving a Message Adjust the volume as necessaryListen for a reply Transmitting a MessagePress the Menu button until Scan A/D is displayed Adding Channels To And Deleting Channels From The Scan ListScan Model Using ScanScan DIS - The radio is not programmed to scan Telephone Interconnect CallsPress the Menu button until Phone ap- pears in the display If the SCN status flag is on, press Scan to turn scan offPlacing a Manually Dialed Call Telephone Interconnect Calls System ModelsPress and hold the PTT Button to key the transmitter Placing An Automatically Dialed Call Release the PTT Button when the dial sequence is completeWhile holding the PTT BUTTON, press Release the PTT Button and listen for a dial toneKEY Lock Menu Scan and System models Lock The KeypadUnlock The Keypad Disable The Alert TonesEnable The Alert Tones Programmable FeaturesRadio Programmable Programmable by ChannelOperating Tips When using your two-way radio, remember these rulesBattery Packs Installing the Battery Pack Removing the Battery Pack Installing the Battery PackContains a rechargeable, recyclable Swivel Mount Removal ReplacementBatteries Intrinsically Safe UsagePacity Short Case Accessories Warranty Warranty becomes void if NICKEL-CADMIUM Battery WarrantyPage Emergency Numbers