Ericsson LBI-38377E Unlock The Keypad, Alert Menu Scan and System models, Disable The Alert Tones

Page 25

3.Press the SEL button until "LOCKED" is displayed.

4.To lock the keypad press the EXIT button.

Unlock The Keypad

1.Press the MENU button until "KEY LOCK" appears in the display.

2.Press the SEL button until "UNLOCKED" is displayed.

3.To unlock the keypad press the EXIT button.

"ALERT" MENU (Scan and System models)

The "ALERT" menu allows the alert tones to be disabled or enabled. If this menu is programmed into the radio, disable and enable the alert tones as follows:

Disable The Alert Tones

1.If the "SCN" status flag is on, press SCAN to turn scan off.

2.Press the MENU button until "ALERT" ap- pears in the display.

3.Press the SEL button until "DISABLED" is displayed.

4.To disable the tones press the EXIT button.

Enable The Alert Tones

1.Press the MENU button until "ALERT" ap- pears in the display.

2.Press the SEL button until "ENABLED" is displayed.

3.To enable the tones press the EXIT button.

PROGRAMMABLE FEATURES

The radio’s features or "personality" are pro- grammed using an IBM PC or compatible computer. For field programming, a full screen portable PC can be used. Programming software is provided on 5-1/4 floppy or 3-1/2 inch disks. This software uses a series of screens and windows to guide you through a programming session.

25

Image 25

Contents Operator’s Manual Ericsson Inc Table of Contents TTD Safety Not ApplicableVolume Control Knob Controls ON/OFF SwitchIntroduction Control KnobMonitor Button PTT ButtonEmergency Button PA Personal Radio Side View Front View Menu Button Scan Model Alert Allows the alert tones to be dis- abled or enabledMenu Display KEY Lock Allows the keypad buttons to be locked or unlockedScan Button Exit ButtonChannel ModePA System Model Radio Select Button Dtmf Keypad IndicatorsUniversal Device Connector TX Transmitter enabled On when the radio is transmittingOperation POWER-UP Carrier Control TimerAlert Tones Channel BusyMODE/CHANNEL/CG Selection Press the Menu button until Mode ap- pears in the displayPress the Menu button until Channel appears in the display Receiving a Message Adjust the volume as necessaryListen for a reply Transmitting a MessagePress the Menu button until Scan A/D is displayed Adding Channels To And Deleting Channels From The Scan ListScan DIS - The radio is not programmed to scan Using ScanTelephone Interconnect Calls Scan ModelPress the Menu button until Phone ap- pears in the display If the SCN status flag is on, press Scan to turn scan offPlacing a Manually Dialed Call Telephone Interconnect Calls System ModelsPress and hold the PTT Button to key the transmitter While holding the PTT BUTTON, press Release the PTT Button when the dial sequence is completeRelease the PTT Button and listen for a dial tone Placing An Automatically Dialed CallKEY Lock Menu Scan and System models Lock The KeypadEnable The Alert Tones Disable The Alert TonesProgrammable Features Unlock The KeypadRadio Programmable Programmable by ChannelOperating Tips When using your two-way radio, remember these rulesBattery Packs Installing the Battery Pack Removing the Battery Pack Installing the Battery PackContains a rechargeable, recyclable Swivel Mount Removal ReplacementBatteries Intrinsically Safe UsagePacity Short Case Accessories Warranty Warranty becomes void if NICKEL-CADMIUM Battery WarrantyPage Emergency Numbers