4.While holding the PTT BUTTON, press
either the "*" button or the "#" button as required by the radio system to obtain a telephone line. The radio will transmit the selected tone.
5.Release the PTT BUTTON and listen for a dial tone.
6.When the dial tone is received, press an hold the PTT BUTTON and dial the desired telephone number. As you dial each num- ber, the DTMF sidetone will be heard in the speaker as the radio transmits the DTMF tone.
7.Release the PTT BUTTON when the dial sequence is complete.
8.When the called party answers, press the PTT BUTTON each time you wish to talk (transmit) and release it when you wish to listen (receive). If desired, enable private mode by pressing the PVT button.
9.At the completion of the call, press and hold the PTT BUTTON and then press the "#" or
"*" button as the telephone interconnect system requires. Release the PTT BUT- TON.
Placing An Automatically Dialed Call
Ten (10) telephone numbers can be programmed or stored in the radio for automatic dial operation. Typically, telephone numbers that are programmed into the radio by the maintenance personal each have a specific name (8 characters maximum) assigned. For example: "OFFICE" or "HOME". Telephone numbers that are stored in the radio using the nu- meric keypad are named "PHONE x" (where "x" is the storage location 1 - 10) when they are stored. When stored numbers are later recalled using the "PHONE" menu, the last eight (8) entered digits of the number will be the name that appears in the display. To recall a programmed or stored number and complete a call, proceed as follows:
1.If the "SCN" status flag is on, press SCAN to turn scan off.
2.Select a channel in your radio system that has telephone interconnect capability. The radio should be programmed for DTMF op- eration on this channel.
3.Press the MENU button until "PHONE" ap- pears in the display.
23