Ericsson LBI-38377E manual Contains a rechargeable, recyclable, Swivel Mount Removal Replacement

Page 30

Chargers are available with nominal charge times of 1 hour (rapid) and 14 hours (standard). Combinations include single (1) and multi (5) posi- tion, standard and rapid charge units. In addition, the vehicular chargers/repeaters simultaneously charge the battery packs while the radio is operating. For specific instructions refer to the applicable charger Operating Manual.

The rechargeable batteries used with the radio can develop a reduced capacity condition sometimes called the "Memory Effect". This condition can occur when a battery is continuously charged for long periods or when a regularly performed duty cycle allows the battery to expend only a limited portion of its capacity. The battery pack may show a severe decrease in its ability to deliver full capacity for an extended period. Any rechargeable battery pack showing signs of reduced capacity should be re- turned to a qualified service center for inspection.

RECHARGEABLE BATTERY PACK DISPOSAL

The product that you have purchased

contains a rechargeable, recyclable

battery. At the end of its useful life,

under various state and local laws, it may be illegal to dispose of this bat- tery into the municipal waste stream. Check with your

local solid waste officials for details in your area for recycling options or proper disposal. Call Toll Free 1-800-8-BATTERY for information and/or proce- dures for returning rechargeable batteries in your state.

SWIVEL MOUNT REMOVAL AND

REPLACEMENT

To remove the swivel mount, slide a flat blade screwdriver underneath the spring retainer and twist. While twisting, slide the swivel mount out from under the holder. See Figure 10.

To replace the swivel mount, place the end of the swivel in the grooves in the radio and slide the mount up until it snaps in place.

30

Image 30

Contents Operator’s Manual Ericsson Inc Table of Contents Safety Not Applicable TTDIntroduction Controls ON/OFF SwitchVolume Control Knob Control KnobPTT Button Monitor ButtonEmergency Button PA Personal Radio Side View Front View Menu Display Alert Allows the alert tones to be dis- abled or enabledMenu Button Scan Model KEY Lock Allows the keypad buttons to be locked or unlockedChannel Exit ButtonScan Button ModePA System Model Radio Select Button Indicators Dtmf KeypadTX Transmitter enabled On when the radio is transmitting Universal Device ConnectorAlert Tones Carrier Control TimerOperation POWER-UP Channel BusyPress the Menu button until Mode ap- pears in the display MODE/CHANNEL/CG SelectionPress the Menu button until Channel appears in the display Adjust the volume as necessary Receiving a MessageTransmitting a Message Listen for a replyAdding Channels To And Deleting Channels From The Scan List Press the Menu button until Scan A/D is displayedTelephone Interconnect Calls Using ScanScan DIS - The radio is not programmed to scan Scan ModelIf the SCN status flag is on, press Scan to turn scan off Press the Menu button until Phone ap- pears in the displayTelephone Interconnect Calls System Models Placing a Manually Dialed CallPress and hold the PTT Button to key the transmitter Release the PTT Button and listen for a dial tone Release the PTT Button when the dial sequence is completeWhile holding the PTT BUTTON, press Placing An Automatically Dialed CallLock The Keypad KEY Lock Menu Scan and System modelsProgrammable Features Disable The Alert TonesEnable The Alert Tones Unlock The KeypadProgrammable by Channel Radio ProgrammableWhen using your two-way radio, remember these rules Operating TipsBattery Packs Installing the Battery Pack Installing the Battery Pack Removing the Battery PackSwivel Mount Removal Replacement Contains a rechargeable, recyclableIntrinsically Safe Usage BatteriesPacity Short Case Accessories Warranty NICKEL-CADMIUM Battery Warranty Warranty becomes void ifPage Emergency Numbers