Ericsson LBI-38377E manual Receiving a Message, Adjust the volume as necessary

Page 17

2.Press the SEL button until the desired mode’s name appears in the display.

3.Press the MENU button until "CHANNEL" appears in the display.

4.Press the SEL button until the desired chan- nel’s name appears in the display.

5.Press the EXIT button to switch radio opera- tion to the new mode and channel, and exit the menu.

6.Select the desired Channel Guard using the CONTROL KNOB. The "CG" status flag will turn on if the selected position has CG programmed. Position fifteen (15) is a non- CG position; it may not be programmed with a Channel Guard. Position sixteen (16) is a default channel CG position; selecting it will switch CG to the CG programmed for the selected channel.

RECEIVING A MESSAGE

1.Slide the ON/OFF SWITCH on the battery pack to the on position. The radio will initiate

and complete the power-up self-test and beep if the power-up alert tone is pro- grammed on.

2.Select the desired operating mode, chan- nel, and/or Channel Guard. See the MODE/CHANNEL/CG SELECTION for de- tails.

3.Press the MONITOR BUTTON to disable squelch and adjust the VOLUME CON- TROL KNOB for the approximate desired speaker audio level. Pressing the MONI- TOR BUTTON may affect Channel Guard and/or Type 99 tone operation if pro- grammed for the selected channel.

4.When a transmission is received, the re- ceiver will unsquelch and it will be heard in the speaker. However, if the selected chan- nel is programmed for Channel Guard or Type 99 tone operation, the receiver will not unsquelch unless the correct CG or T99 tone is received.

5.Adjust the volume as necessary.

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Operator’s Manual Ericsson Inc Table of Contents TTD Safety Not ApplicableVolume Control Knob Controls ON/OFF SwitchIntroduction Control KnobEmergency Button PTT ButtonMonitor Button PA Personal Radio Side View Front View Menu Button Scan Model Alert Allows the alert tones to be dis- abled or enabledMenu Display KEY Lock Allows the keypad buttons to be locked or unlockedScan Button Exit ButtonChannel ModePA System Model Radio Select Button Dtmf Keypad IndicatorsUniversal Device Connector TX Transmitter enabled On when the radio is transmittingOperation POWER-UP Carrier Control TimerAlert Tones Channel BusyPress the Menu button until Channel appears in the display Press the Menu button until Mode ap- pears in the displayMODE/CHANNEL/CG Selection Receiving a Message Adjust the volume as necessaryListen for a reply Transmitting a MessagePress the Menu button until Scan A/D is displayed Adding Channels To And Deleting Channels From The Scan ListScan DIS - The radio is not programmed to scan Using ScanTelephone Interconnect Calls Scan ModelPress the Menu button until Phone ap- pears in the display If the SCN status flag is on, press Scan to turn scan offPress and hold the PTT Button to key the transmitter Telephone Interconnect Calls System ModelsPlacing a Manually Dialed Call While holding the PTT BUTTON, press Release the PTT Button when the dial sequence is completeRelease the PTT Button and listen for a dial tone Placing An Automatically Dialed CallKEY Lock Menu Scan and System models Lock The KeypadEnable The Alert Tones Disable The Alert TonesProgrammable Features Unlock The KeypadRadio Programmable Programmable by ChannelOperating Tips When using your two-way radio, remember these rulesBattery Packs Installing the Battery Pack Removing the Battery Pack Installing the Battery PackContains a rechargeable, recyclable Swivel Mount Removal ReplacementPacity Short Case Intrinsically Safe UsageBatteries Accessories Warranty Warranty becomes void if NICKEL-CADMIUM Battery WarrantyPage Emergency Numbers
Top Page Image Contents