Ericsson LBI-38377E manual MODE/CHANNEL/CG Selection

Page 16

If programmed on, the power-up alert tone (beep) will be heard.

MODE/CHANNEL/CG SELECTION

The M-PA Scan and System model radios may be programmed with up to 192 different radio chan- nels. A maximum of 12 modes of 16 channels each or 16 modes of 12 channels each may be pro- grammed into the radio (12 x 16 = 192). Select the desired mode (bank of channels) and channel, or channel and Channel Guard (CG), according to the radio’s programming as follows:

MENU And SEL Selects Mode

CONTROL KNOB Selects Channel (And CG)

1.Press the MENU button until "MODE" ap- pears in the display.

2.Press the SEL button to select the desired mode. The selected mode’s name will ap- pear in the display.

3.Press the EXIT button to switch radio opera- tion to the selected mode and exit the menu.

4.Select the desired channel by rotating the CONTROL KNOB until the desired chan- nel’s name appears in the display.

CONTROL KNOB Selects Mode

MENU And SEL Selects Channel (And CG)

1.Select the correct mode by rotating the CONTROL KNOB until the desired mode’s name appears in the display.

2.Press the MENU button until "CHANNEL" appears in the display.

3.Press the SEL button until the desired chan- nel’s name appears in the display.

4.Press the EXIT button to switch radio opera- tion to the displayed channel and exit the menu.

MENU and SEL Selects Modes And Channels CONTROL KNOB Selects Channel Guard

1.Press the MENU button until "MODE" ap- pears in the display.

16

Image 16

Contents Operator’s Manual Ericsson Inc Table of Contents Safety Not Applicable TTDControls ON/OFF Switch Volume Control KnobIntroduction Control KnobMonitor Button PTT ButtonEmergency Button PA Personal Radio Side View Front View Alert Allows the alert tones to be dis- abled or enabled Menu Button Scan ModelMenu Display KEY Lock Allows the keypad buttons to be locked or unlockedExit Button Scan ButtonChannel ModePA System Model Radio Select Button Indicators Dtmf KeypadTX Transmitter enabled On when the radio is transmitting Universal Device ConnectorCarrier Control Timer Operation POWER-UPAlert Tones Channel BusyMODE/CHANNEL/CG Selection Press the Menu button until Mode ap- pears in the displayPress the Menu button until Channel appears in the display Adjust the volume as necessary Receiving a MessageTransmitting a Message Listen for a replyAdding Channels To And Deleting Channels From The Scan List Press the Menu button until Scan A/D is displayedUsing Scan Scan DIS - The radio is not programmed to scanTelephone Interconnect Calls Scan ModelIf the SCN status flag is on, press Scan to turn scan off Press the Menu button until Phone ap- pears in the displayPlacing a Manually Dialed Call Telephone Interconnect Calls System ModelsPress and hold the PTT Button to key the transmitter Release the PTT Button when the dial sequence is complete While holding the PTT BUTTON, pressRelease the PTT Button and listen for a dial tone Placing An Automatically Dialed CallLock The Keypad KEY Lock Menu Scan and System modelsDisable The Alert Tones Enable The Alert TonesProgrammable Features Unlock The KeypadProgrammable by Channel Radio ProgrammableWhen using your two-way radio, remember these rules Operating TipsBattery Packs Installing the Battery Pack Installing the Battery Pack Removing the Battery PackSwivel Mount Removal Replacement Contains a rechargeable, recyclableBatteries Intrinsically Safe UsagePacity Short Case Accessories Warranty NICKEL-CADMIUM Battery Warranty Warranty becomes void ifPage Emergency Numbers