Panasonic ES7109 operating instructions Replacing the system outer foil and the inner, Blades

Page 10

English	Replacing the system outer foil and the inner
	blades
			system outer foil	once every year
			inner blade	once every two years
	1Replacing the system outer foil
			1. Press the system outer foil
			release buttons and lift the
			system outer foil upwards as
			illustrated.
			2. Insert the system outer foil by
			pushing it downwards until it
			clicks.
	1Replacing the inner blades
			1. Press the foil frame release
			buttons and lift the foil frame
			upwards as illustrated.
			2. Remove the inner blades one
			at a time as illustrated.
			• Do not touch the edges
			(metal parts) of the inner
			blades to prevent injury to
	2	3	your hand.
	2	3	3. Insert the inner blades one at
			3. Insert the inner blades one at
			a time until they click as
			illustrated.

10

Cleaning the self-cleaning recharger

Beard trimmings may become attached to the cleaning tray of the self-cleaning recharger. Follow the steps below to remove them. We recommend doing this each time you change the detergent cartridge.

1	1. Be sure to remove the water
	tank and the appliance plug
	from the self-cleaning
	recharger.
	• Be careful not to spill the
	cleaning liquid.
	2. Gently wipe off any beard
	trimmings attached to the
2	inside of the cleaning tray
	with a cloth or tissue paper
	dampened with water.
	• Clean the corners and
	uneven parts of the cleaning
	tray with a cotton swab
	dampened with water.

•Do not pull hard on the rubber blade protector at the bottom of the cleaning tray. The rubber may come off if you pull hard on it. It is only necessary to pull it up slightly.

•Warning - Do not wash or apply water to the adaptor or self- cleaning recharger. Failure to observe this may cause electric shock or result in short circuits.

Image 10

Contents English Français Español Important Safety Instructions Before use Operating environment for the self-cleaning recharger Parts identificationCharging with the self-cleaning recharger Push down the arm until it clicksUsing the trimmer Reading the LCD panelCleaning with the self-cleaning recharger 1Preparing the self-cleaning rechargerPlug in the adaptor 1Cleaning the shaverPush down the arm Press select to select the course 11 1 1 Cleaning with the self-cleaning recharger Cleaning the shaver without the self-cleaning rechargerBlades Cleaning the self-cleaning rechargerReplacing the system outer foil and the inner 1Replacing the system outer foil1When the water does not drain from the cleaning tray Removing the built-in rechargeable batteriesConsignes DE Sécurité Importantes FrançaisNettoyage du rasoir Avant utilisationUtilisation du rasoir Chargement du rasoir Rangement du rasoirIdentification des pièces Environnement de fonctionnement du chargeur autonettoyantAbaissez le bras jusqu’à ce qu’il émette un clic Chargement à l’aide du chargeur autonettoyantChargement sans le chargeur autonettoyant Appuyez sur le Tenez le rasoir comme Bouton de Utilisation du rasoir 90˚Propos du panneau ACL HautCachets Nettoyage à l’aide du chargeur autonettoyant1Préparation du chargeur autonettoyant Fixez la cartouche de détergent1Nettoyage du rasoir Insérez la prise dans l’appareil Branchez l’adaptateur11 1 1 Nettoyage à l’aide du chargeur autonettoyant suite Nettoyage du rasoir sans le chargeur autonettoyant1Remplacement des lames intérieures 1Remplacement de la grille de protection du systèmeNettoyage du chargeur autonettoyant 1Lorsque l’eau ne sort pas du plateau de nettoyage Retrait des batteries rechargeables intégréesInstruccionesdeseguridadimportantes Peligro Para reducir el riesgo de descargas eléctricasImportante Identificación de las partes Si no se ilumina, espere un tiempo hasta que se ilumineEmpuje el brazo hasta que haga clic Carga con el recargador de limpieza automáticaApague la afeitadora antes de instalarla Utilización de la afeitadora 90˚ Limpieza con el recargador de limpieza automática 1Preparación del recargador de limpieza automáticaPulse select para seleccionar el programa 1Limpieza de la afeitadoraInserte el enchufe del dispositivo Enchufe el adaptador Empuje el brazo hacia abajoLimpie las gotas de agua con un paño seco Continúe con el programaCuando la lámpara de estado se apaga 1Sustitución de las cuchillas internas 1Sustitución de la lámina exterior del sistemaLimpieza del recargador de limpieza automática 1Cuando el agua no se vacía de la bandeja de limpieza Eliminación de las baterías recargables integradasNo.1 EN FR ES U.S.A./CANADA