Panasonic ES7109 operating instructions 11 1 1 Cleaning with the self-cleaning recharger

Page 9

11 1 1 Cleaning with the self-cleaning recharger (continued)

Follow the steps outlined below if the status lamp blinks or glows during the “Clean/Dry/Charge” course or the “Clean/Dry” course.

Cleaning the shaver without the self-cleaning recharger

English

Blinks

Correctly set the detergent cartridge and then restart a course.

If the status lamp goes out

Continue a course.

Glows

Remove the shaver from the self- cleaning recharger and then check that the [clean] lamp has gone out. (Be careful as the blade may be hot or wet.) Check that the water tank is correctly attached, the water tank cap is securely closed and the self- cleaning recharger is placed horizontally.

1. Disconnect the power cord from the shaver.

2. Apply some hand soap to the outer foil.

3. Turn the shaver on and then

pour some water over the outer foil.

4. Turn the shaver off after 10-20 seconds.

5. Remove the foil frame and clean it with running water.

When an abnormality has been corrected

Press and hold [select] for approximately 2 seconds to turn off the status lamp and then restart a course.

When no abnormality was found

It is time to replace the detergent cartridge and cleaning liquid inside the water tank.

Drain the old cleaning liquid inside the water tank and then refill it with water. Replace the old detergent cartridge and then restart the course.

6. Wipe off any drops of water with a dry cloth.

7. Remove the system outer foil and the foil frame to allow them to dry completely.

When the status lamp goes out

Continue a course.

When the status lamp glows again

Contact an authorized service center.

Image 9

Contents English Français Español Important Safety Instructions Before use Parts identification Operating environment for the self-cleaning rechargerPush down the arm until it clicks Charging with the self-cleaning rechargerReading the LCD panel Using the trimmer1Preparing the self-cleaning recharger Cleaning with the self-cleaning recharger1Cleaning the shaver Plug in the adaptorPush down the arm Press select to select the course Cleaning the shaver without the self-cleaning recharger 11 1 1 Cleaning with the self-cleaning rechargerReplacing the system outer foil and the inner Cleaning the self-cleaning rechargerBlades 1Replacing the system outer foilRemoving the built-in rechargeable batteries 1When the water does not drain from the cleaning trayFrançais Consignes DE Sécurité ImportantesUtilisation du rasoir Chargement du rasoir Avant utilisationNettoyage du rasoir Rangement du rasoirEnvironnement de fonctionnement du chargeur autonettoyant Identification des piècesChargement à l’aide du chargeur autonettoyant Abaissez le bras jusqu’à ce qu’il émette un clicChargement sans le chargeur autonettoyant Propos du panneau ACL Utilisation du rasoir 90˚Appuyez sur le Tenez le rasoir comme Bouton de Haut1Préparation du chargeur autonettoyant Nettoyage à l’aide du chargeur autonettoyantCachets Fixez la cartouche de détergentInsérez la prise dans l’appareil Branchez l’adaptateur 1Nettoyage du rasoirNettoyage du rasoir sans le chargeur autonettoyant 11 1 1 Nettoyage à l’aide du chargeur autonettoyant suite1Remplacement de la grille de protection du système 1Remplacement des lames intérieuresNettoyage du chargeur autonettoyant Retrait des batteries rechargeables intégrées 1Lorsque l’eau ne sort pas du plateau de nettoyagePeligro Para reducir el riesgo de descargas eléctricas InstruccionesdeseguridadimportantesImportante Si no se ilumina, espere un tiempo hasta que se ilumine Identificación de las partesCarga con el recargador de limpieza automática Empuje el brazo hasta que haga clicApague la afeitadora antes de instalarla Utilización de la afeitadora 90˚ 1Preparación del recargador de limpieza automática Limpieza con el recargador de limpieza automáticaInserte el enchufe del dispositivo Enchufe el adaptador 1Limpieza de la afeitadoraPulse select para seleccionar el programa Empuje el brazo hacia abajoContinúe con el programa Limpie las gotas de agua con un paño secoCuando la lámpara de estado se apaga 1Sustitución de la lámina exterior del sistema 1Sustitución de las cuchillas internasLimpieza del recargador de limpieza automática Eliminación de las baterías recargables integradas 1Cuando el agua no se vacía de la bandeja de limpiezaNo.1 EN FR ES U.S.A./CANADA