Panasonic ES7109 operating instructions Cleaning with the self-cleaning recharger

Page 7

Cleaning with the self-cleaning recharger

1Preparing the self-cleaning recharger

Remove the shaver and the appliance plug from the self-cleaning recharger.

English



2

1 

1 Remove the water tank and then open the water tank cap.

2 Wash away the old cleaning liquid and then rinse the water tank.

3 4

3 Pour tap water into the water tank.

•Do not let the water rise above the maximum water line. This may cause the cleaning liquid to spill.

4 Securely close the water tank cap and then attach the tank.




5 Peel off the seals	6 Attach the detergent
from the new	cartridge.
detergent cartridge.
(2 seals)

•Hold the detergent cartridge horizontally. (The detergent may spill if the detergent cartridge is tilted too much.)

• Replace the HydraClean™ Shaving System Solution Cartridge when					away the detergent cartridge and the cleaning liquid.
	the status lamp is illuminated. Use the below chart as a guide.				• Only use self-cleaning recharger detergent for Panasonic shavers.
	Shaving	Cleaning	Reusability		• Always change the detergent cartridge and the cleaning liquid in the
					water tank at the same time. Adding water, or changing just the
		1 time/day	approx. 30-40 times
		1 time/day	approx. 30-40 times		detergent cartridge or the water, will result in deteriorated cleaning
	1 time/day	1 time/3 days	approx. 10-15 times
	1 time/day	1 time/3 days	approx. 10-15 times		functions.
		1 time/week	approx. 4-7 times		• If you operate the self-cleaning recharger, the concentrated detergent
	The expiration date of the cleaning liquid is 6 months after it is opened.				in the detergent cartridge dilutes and the water inside the tank will
					become a cleaning liquid.
	If you do not use the cleaning liquid for more than 6 months, throw

Image 7

Contents English Français Español Important Safety Instructions Before use Parts identification Operating environment for the self-cleaning rechargerPush down the arm until it clicks Charging with the self-cleaning rechargerReading the LCD panel Using the trimmer1Preparing the self-cleaning recharger Cleaning with the self-cleaning rechargerPlug in the adaptor 1Cleaning the shaverPush down the arm Press select to select the course Cleaning the shaver without the self-cleaning recharger 11 1 1 Cleaning with the self-cleaning recharger1Replacing the system outer foil Cleaning the self-cleaning rechargerReplacing the system outer foil and the inner BladesRemoving the built-in rechargeable batteries 1When the water does not drain from the cleaning trayFrançais Consignes DE Sécurité ImportantesRangement du rasoir Avant utilisationUtilisation du rasoir Chargement du rasoir Nettoyage du rasoirEnvironnement de fonctionnement du chargeur autonettoyant Identification des piècesAbaissez le bras jusqu’à ce qu’il émette un clic Chargement à l’aide du chargeur autonettoyantChargement sans le chargeur autonettoyant Haut Utilisation du rasoir 90˚Propos du panneau ACL Appuyez sur le Tenez le rasoir comme Bouton deFixez la cartouche de détergent Nettoyage à l’aide du chargeur autonettoyant1Préparation du chargeur autonettoyant CachetsInsérez la prise dans l’appareil Branchez l’adaptateur 1Nettoyage du rasoirNettoyage du rasoir sans le chargeur autonettoyant 11 1 1 Nettoyage à l’aide du chargeur autonettoyant suite1Remplacement des lames intérieures 1Remplacement de la grille de protection du systèmeNettoyage du chargeur autonettoyant Retrait des batteries rechargeables intégrées 1Lorsque l’eau ne sort pas du plateau de nettoyagePeligro Para reducir el riesgo de descargas eléctricas InstruccionesdeseguridadimportantesImportante Si no se ilumina, espere un tiempo hasta que se ilumine Identificación de las partesEmpuje el brazo hasta que haga clic Carga con el recargador de limpieza automáticaApague la afeitadora antes de instalarla Utilización de la afeitadora 90˚ 1Preparación del recargador de limpieza automática Limpieza con el recargador de limpieza automáticaEmpuje el brazo hacia abajo 1Limpieza de la afeitadoraInserte el enchufe del dispositivo Enchufe el adaptador Pulse select para seleccionar el programaLimpie las gotas de agua con un paño seco Continúe con el programaCuando la lámpara de estado se apaga 1Sustitución de las cuchillas internas 1Sustitución de la lámina exterior del sistemaLimpieza del recargador de limpieza automática Eliminación de las baterías recargables integradas 1Cuando el agua no se vacía de la bandeja de limpiezaNo.1 EN FR ES U.S.A./CANADA