Agilent Technologies FS2334 user manual Appendix

Page 3

Overview	18
State Analysis Operation – Read and Writes above 667MT/s	18
State Analysis Operation – Read and Write at 667MT/s or slower	19
State Analysis Operation – Read or Write at 800MT/s	19
The process for setting sampling positions at speeds of 800MT/s:	20
State analysis calibration procedure	21
Adjusting the sampling positions with controlled stimulus	24
State Display	26
DDR2 Protocol Checking and Performance Tool (FS1140)	27
FS1140 Installation and Licensing	27
Loading the FS1140	27
Setting up the FS1140 DDR2 Tool	28
Functional and Performance Analysis – NOTE: The Functional Performance portion of this
software will NOT work with 2 FRAME configurations	29
Statistics	29
Errors	29
Export	30
Repetitive Run	30
Timing Analysis	30
Export	30
Appendix	32
FS2334 Signal to Logic Analyzer Connector and Channel Mapping	32

3

Image 3

Contents DDR2 Dimm High Speed Probe FS2334 Product Warranty Appendix For Sales and Marketing Support For Technical SupportExclusive Remedies Product WarrantySoftware License Agreement Definitions IntroductionProbe Technical Feature Summary FS2334 Probe DescriptionProbe Components Signal Assignments on Probe Pods Signal Threshold Voltage SettingsConnecting the DDR2 Probe to the Logic Analyzer Test Points Connecting to your Target System Signal Isolation on the ProbeBuffered signals on the probe Write state analysis Page Setting up the 169xx Analyzer Software Requirements169xx Licensing Offline Analysis Page Decoding DDR Commands TimingZoom AnalysisTaking a Trace, Triggering, and Seeing Measurement Results Overview State AnalysisState Analysis Operation Read and Write at 667MT/s or slower Process for setting sampling positions at speeds of 800MT/s State analysis calibration procedure Page Page Adjusting the sampling positions with controlled stimulus Page State Display Loading the FS1140 FS1140 Installation and LicensingSetting up the FS1140 DDR2 Tool Statistics Timing Analysis ExportPage Appendix Header 1 CommandDP16P/ CLK CK0 Header 2 Command NC3 Header 3 Write DQ9 Header 4 Write Ground D13 DQ22 20K ohm to D14 DQ18 D15 DQ23 Header 5 Write CB0 CB1 20K ohm to Ground D13 No connection D14 D15 Header 6 Write DM5DQS14 Header 7 -Write 20K ohm to Ground D13 DQ50 D14 DQ55 D15 DQ51 Header 8 Write SDA Header 12 Read Duplicates only data signals 20K ohm to Ground D15 No connection Header 10 Read Duplicates only data signals DP16P/ CLK CB7 Header 11 Read Duplicates only data signals DP16P/ CLK RAS Header 9 Read Duplicates only data signals DP16P/ CLK CK2 Header 13 Read Duplicates only data signals Ground D13 DQ50 20K ohm to D14 DQ55 D15 DQ51