Agilent Technologies FS2334 user manual Export, Timing Analysis

Page 30

Export

This function takes the data captured and exports it in .csv format to a location the user selects.

Repetitive Run

This function allows the user to set-up the tool to trigger the logic analyzer a predefined number of times and capture data incrementally on each run. Please note this function does not work in Off Line mode.

Timing Analysis

This window tab provides an analysis of each Data bit’s window during every data burst across an entire TimingZoom trace. The user can set a threshold criteria in this window and then select whether the data windows to be identified should be equal to, greater than or equal to, or less than or equal to that value. All Data bits during any burst captured in a TZ trace will be listed in the Timing Analysis window.

Additionally, the tool provides some overall statistics on what was measured in the TZ trace that was analyzed. This includes the number of Read and Write strobes analyzed, the % of data strobes with data transitions occurring; as well as, the maximum, minimum and average Data Bit widths across ALL bits during ALL bursts in the TZ trace.

Export

This function takes the data captured and exports it in .csv format to a location the user selects.

30

Image 30

Contents DDR2 Dimm High Speed Probe FS2334 Product Warranty Appendix For Technical Support For Sales and Marketing SupportProduct Warranty Exclusive RemediesSoftware License Agreement Introduction DefinitionsProbe Technical Feature Summary FS2334 Probe DescriptionProbe Components Signal Assignments on Probe Pods Signal Threshold Voltage SettingsConnecting the DDR2 Probe to the Logic Analyzer Test Points Connecting to your Target System Signal Isolation on the ProbeBuffered signals on the probe Write state analysis Page Setting up the 169xx Analyzer Software Requirements169xx Licensing Offline Analysis Page Decoding DDR Commands TimingZoom AnalysisTaking a Trace, Triggering, and Seeing Measurement Results State Analysis OverviewState Analysis Operation Read and Write at 667MT/s or slower Process for setting sampling positions at speeds of 800MT/s State analysis calibration procedure Page Page Adjusting the sampling positions with controlled stimulus Page State Display FS1140 Installation and Licensing Loading the FS1140Setting up the FS1140 DDR2 Tool Statistics Export Timing AnalysisPage Header 1 Command AppendixDP16P/ CLK CK0 Header 2 Command NC3 Header 3 Write DQ9 Header 4 Write Ground D13 DQ22 20K ohm to D14 DQ18 D15 DQ23 Header 5 Write CB0 CB1 20K ohm to Ground D13 No connection D14 D15 Header 6 Write DM5DQS14 Header 7 -Write 20K ohm to Ground D13 DQ50 D14 DQ55 D15 DQ51 Header 8 Write SDA Header 12 Read Duplicates only data signals 20K ohm to Ground D15 No connection Header 10 Read Duplicates only data signals DP16P/ CLK CB7 Header 11 Read Duplicates only data signals DP16P/ CLK RAS Header 9 Read Duplicates only data signals DP16P/ CLK CK2 Header 13 Read Duplicates only data signals Ground D13 DQ50 20K ohm to D14 DQ55 D15 DQ51