Braun 950787 manual To Clear the Total Infused, To Exit Standby Function

Page 19

OPTIONS	Total Infused, Standby Function

TOTAL INFUSED

The Total Infused information screen displays the total amount of fluid in ml that has been pumped since the last time the Total Infused was cleared.

1. Press OPTS until display shows Tot Infused=.

2. Press

3. Press END.

This function allows the pump to be put on standby while retaining all set infusion data. This function is only available in Continuous Mode.

1.Press OPTS until display shows STANDBY

2.Press ON.

3.Enter time in hours and minutes the pump is to stand by.

4.Press C to clear the current data and re-enter new data. Press OK to accept new data.

4.Press OK.

The pump will count down to zero and then alarm Pump Stopped!

1.Press EXIT to return to Continuous Mode.

Note: If countdown has already started, press END to return to Continuous Mode.

Vista™ basic Instructions for Use	18/25
950787 Rev H 02/03

Image 19

Contents Instructions for Use Vista basicVista basic Instructions for Use 950787 Rev H 02/03 Vista basic Contents Vista basic Instructions for Use 950787 Rev H 02/03 Safety Standard Introduction Function Keys Door Open Button Aluminum CaseLoad the Set Preparing the InfusionPrepare the Pump Turn on the PumpYES Continuous ModeContinuous Mode Rate and Vtbd Volume To Be DeliveredTo Change the Rate To Change the Rate While InfusingVtbd and Time Rate and TimeInformation KEY Keep Vein Open RatePiggyback OptionsPiggyback To Exit Piggyback Piggyback, Ramp/Taper ModeRAMP/TAPER Mode To Review or Change Ramp/Taper Mode DataFast Taper Ramp/Taper ModeTo Clear Ramp/Taper Mode To Exit Ramp/Taper ModeTo Clear Program Mode Program ModeProgram Mode To Review or Change Program Mode dataDelay a Mode Delay a ModeTo Exit Delay a Mode To Exit Dosage Calculation Dosage CalculationDosage Calculation To Review Data During InfusionBolus Without Entering a Volume Bolus ModeInterval Bolus Intermittent Mode To Exit Standby Function Total InfusedTo Clear the Total Infused StandbyTo Turn On the Drop Sensor Battery CapacityOcclusion Pressure Drop SensorContrast Selection Data Lock, Contrast SelectionData Lock To Turn Off Data LockAdjust Clock Adjust Clock, LoudnessLoudness Alarm Possible Cause Action AlarmsCC Interface AC, 12 V, BATTERY, & CC InterfaceBattery Operation AC and 12Storage MAINTENANCE, STORAGE, & ServiceMaintenance ServiceSpecifications 2001 B. Braun Medical Inc