Braun 950787 manual AC, 12 V, BATTERY, & CC Interface, AC and 12, Battery Operation

Page 24

AC, 12 V, BATTERY, & CC INTERFACE

♦Check AC voltage as per rating label.

♦Insert/screw on power lead (12 V lead in ambulance car) on back.

♦Switching to internal battery is automatic in the event of power failure or if 12 V or AC is not connected.

♦Charge battery on initial use, following a battery alarm, or after 2 months of non-use.

♦Charging time: approx. 16 hours. Longer charging has no detrimental effect.

♦Full battery provides operation for 3.5 hours at 125 mL/hr.

♦Battery capacity is approx. 50% after 2 years.

♦The service life of the battery can be extended by completely discharging it from time to time and then fully recharging it on AC power.

Interface descriptions available from B. Braun. Connection to interface input uses MFC plug.

Documentation

♦All operating data of the Vista™ basic can be called up and logged via external computer

Vista™ basic Instructions for Use	23/25
950787 Rev H 02/03

Image 24

Contents Vista basic Instructions for UseVista basic Instructions for Use 950787 Rev H 02/03 Vista basic Contents Vista basic Instructions for Use 950787 Rev H 02/03 Safety Standard Introduction Door Open Button Aluminum Case Function KeysPreparing the Infusion Prepare the PumpTurn on the Pump Load the SetContinuous Mode Continuous ModeRate and Vtbd Volume To Be Delivered YESTo Change the Rate While Infusing Vtbd and TimeRate and Time To Change the RateKeep Vein Open Rate Information KEYOptions PiggybackPiggyback Piggyback, Ramp/Taper Mode RAMP/TAPER ModeTo Review or Change Ramp/Taper Mode Data To Exit PiggybackRamp/Taper Mode To Clear Ramp/Taper ModeTo Exit Ramp/Taper Mode Fast TaperProgram Mode Program ModeTo Review or Change Program Mode data To Clear Program ModeDelay a Mode Delay a ModeTo Exit Delay a Mode Dosage Calculation Dosage CalculationTo Review Data During Infusion To Exit Dosage CalculationBolus Mode Bolus Without Entering a VolumeInterval Bolus Intermittent Mode Total Infused To Clear the Total InfusedStandby To Exit Standby FunctionBattery Capacity Occlusion PressureDrop Sensor To Turn On the Drop SensorData Lock, Contrast Selection Data LockTo Turn Off Data Lock Contrast SelectionAdjust Clock, Loudness Adjust ClockLoudness Alarms Alarm Possible Cause ActionAC, 12 V, BATTERY, & CC Interface Battery OperationAC and 12 CC InterfaceMAINTENANCE, STORAGE, & Service MaintenanceService StorageSpecifications 2001 B. Braun Medical Inc