Braun 950787 manual Preparing the Infusion, Prepare the Pump, Turn on the Pump, Load the Set

Page 8

PREPARING THE INFUSION

Prepare the Pump

1.Check for cleanliness, completeness, and damage. If unit appears damaged, do not use it.

2.Attach the pump to an IV pole by turning the knob on the pole clamp clockwise, or place the pump on a flat, stable surface.

3.Plug the pump’s power cord into an electrical outlet.

Turn on the Pump

1. Press

(ON/OFF).

2.Listen for 3 loud beeps.

3.Check screen for completeness of all pixels on the display. The Alarm () and Infusing (6) lights will blink once.

Load the Set

1.Prepare the solution container and prime the administration set according to the instructions provided on the set package. Close the roller clamp.

2.Check that the drip chamber is about 1/3 full and there is no air in the set.

3.Open the pump door by pressing the Door Open Button on the top right corner of the pump.

4.Push and hold open the clamp at the top of the fluid path.

5.Insert tubing in clamp and release clamp.

6.Thread the tubing down the fluid path, making sure the tubing is pressed into the Air-in-Line detector at the bottom of the fluid path. The roller clamp should be below the pump.

7.Close the door and open the roller clamp. Check that no drops are falling in the drip chamber.

8.Place drop sensor on drip chamber (optional).

9.Connect set to patient site.

Turning off the Pump

 

1.

Press

to stop the infusion.

2.

Close the roller clamp.

 

3.

Press and hold

for 2 seconds.

Vista™ basic Instructions for Use

7/25

950787 Rev H 02/03

 

 

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Vista basic Instructions for UseVista basic Instructions for Use 950787 Rev H 02/03 Vista basic Contents Vista basic Instructions for Use 950787 Rev H 02/03 Safety Standard Introduction Door Open Button Aluminum Case Function KeysPreparing the Infusion Prepare the PumpTurn on the Pump Load the SetContinuous Mode Continuous ModeRate and Vtbd Volume To Be Delivered YESTo Change the Rate While Infusing Vtbd and TimeRate and Time To Change the RateKeep Vein Open Rate Information KEYPiggyback OptionsPiggyback Piggyback, Ramp/Taper Mode RAMP/TAPER ModeTo Review or Change Ramp/Taper Mode Data To Exit PiggybackRamp/Taper Mode To Clear Ramp/Taper ModeTo Exit Ramp/Taper Mode Fast TaperProgram Mode Program ModeTo Review or Change Program Mode data To Clear Program ModeTo Exit Delay a Mode Delay a ModeDelay a Mode Dosage Calculation Dosage CalculationTo Review Data During Infusion To Exit Dosage CalculationInterval Bolus Intermittent Mode Bolus ModeBolus Without Entering a Volume Total Infused To Clear the Total InfusedStandby To Exit Standby FunctionBattery Capacity Occlusion PressureDrop Sensor To Turn On the Drop SensorData Lock, Contrast Selection Data LockTo Turn Off Data Lock Contrast SelectionLoudness Adjust Clock, LoudnessAdjust Clock Alarms Alarm Possible Cause ActionAC, 12 V, BATTERY, & CC Interface Battery OperationAC and 12 CC InterfaceMAINTENANCE, STORAGE, & Service MaintenanceService StorageSpecifications 2001 B. Braun Medical Inc
Top Page Image Contents