MD42FLW_FLB
ENGLISH
Step 2: Install the lampholder mounting plate to the junction
box (refer to the mounting plate instructions). House supply wires should be sticking out of the front of the mounting plate.
Step 3: Screw the locknut (found in the hardware bag) onto the threaded
end of the mounting plate adapter (G). Feed the | L |
supply wires from the house (coming through | |
the lampholder mounting plate hole) through the |
|
mounting plate adapter hole (Fig. 3). The threaded |
|
end of the mounting plate adapter should be | Fig. 3 |
facing the lampholder mounting plate. |
|
Note: If the house lead wires are not long enough, it may be necessary to attach 6˝ wire extensions.
Step 4: Screw the mounting plate adapter (G) into the lampholder mounting plate.
Note: Use the locknut to adjust and tighten the adapter to the mounting plate.
Step 5: Apply silicone caulk around the mounting plate adapter to ensure a watertight seal.
Step 6: Mount the fixture to the mounting plate adapter (G) using the 3 screws and nuts provided (H) (Fig. 4). House supply wires should be in the bottom area of the fixture
arm at this point.
Fig. 4
Step 7: Make wiring connections inside the fixture arm as described in
“Wiring your fixture.”
Wiring your fixture
Before continuing - turn off the power at the main fuse/breaker box. If the supply wires coming from your house are solid, you can use the Quick- connect™ wire system to attach your Cooper Lighting, LLC light fixture.
Note: Quick connectors can only be used with solid supply wires.
Step 1: Attach your ground supply wire to the fixture using the green ground screw.
Step 2: Simply insert the black supply wire from your house into the quick connector with the black wire coming from the fixture (Fig. 5).
Step 3: Insert the white supply wire from your house into the quick connector with the white wire coming from the fixture (Fig. 5).
Fixture wire
House supply | Fig. 5 |
wire |
|
Step 4: Push both wires firmly into holes to insure that they are seated properly and securely.
Proceed to “Attaching access cover and lens.”
If the supply wires coming from your house are stranded:
Step 1: Remove the quick connectors from the end of the light fixture wires by turning them repeatedly from left to right while pulling. Repeat until they are both removed. Discard these connectors. Do not
Call for customer service and/or missing or damaged parts
4