ENGLISH
-Turn ON the headset by pressing the ON/OFF button until you hear two beep tones. At the same time the red and green LED will lit ones.
-Remove the rubber cover of the power socket so that the hole of the power socket is free. Pull out the rubber cover from the headset so that the registration key hole is free also.
-Press the headset registration key. The red LED will flash rapidly.
-If after a few seconds the green LED flashes slowly, the registration is successful.
-If the red LED flashes slowly, the registration is failed. Repeat above procedure and make sure that the base
6.5 SELECTING A BASE
The handsets can be registered up to 4 bases simultaneously.
To select a base:
1.Enter the menu by pressing 
/OK
2.Select setup using the up 
and down 
keys
3.Press OK
4.Select SEL BASE using the up 
and down 
keys
5.Press OK
6.Select a base or select AUTO using the up 
and down 
keys
7.Press OK
When selecting the base, the currect selected base in indicated by a ‘o’ sign after the base number. If you select ‘Auto’ the handset will automatically search for another base when you are out of range!
7. TROUBLE SHOOTING
Symptom |
| Possible cause | Solution | |
|
|
|
|
|
No display |
| Batteries uncharged | Check the position of the batteries | |
|
|
|
|
|
|
|
|
| Recharge the batteries |
|
|
|
|
|
|
|
| Handset turned OFF | Turn ON the handset |
|
|
|
|
|
No tone |
| Telephone cord badly connected | Check the telephone cord connection | |
|
|
|
|
|
|
|
| The line is occupied by another handset | Wait until the other handset hangs up |
|
|
|
|
|
The icon |
| flashes | Handset out of range | Bring the handset closer to the base |
| ||||
|
|
| ||
|
|
|
|
|
|
|
| The base has no power supply | Check the mains connection to the base |
|
|
|
|
|
|
|
| The handset is not registered on the | Register the handset on the base |
|
|
| base |
|
|
|
|
| |
Base or handset do not ring | The ringing volume is zero or low | Adjust the ringing volume | ||
|
|
|
| |
Tone is good, but there is no | The dialling mode is wrong | Adjust the dialling mode (pulse/tone) | ||
communication |
|
| ||
|
|
|
| |
Not possible to transfer a call on PABX | The FLASH time is too short | Set the unit to Long Flash time | ||
|
|
|
| |
Telephone does not react to pressing the | Manipulation error | Remove the batteries and put them back | ||
keys |
|
| in place | |
|
|
|
|
|
Topcom Butler 2511 Deluxe | 17 |