VTech LS6325-3, LS6325-4, LS6325-5, LS6326-5 My handset beeps and is not performing normally

Page 60

Appendix

Troubleshooting

•Install the battery again and place the handset in the telephone base or charger.

•Wait for the handset to synchronize with the telephone base. Allow up to one minute for this to take place.

My handset beeps and is not performing normally.

•Make sure the power cord is securely plugged into the telephone base. Plug the telephone base into a different working electrical outlet not controlled by a wall switch.

•Move the handset closer to the telephone base. It may be out of range.

•Reset the telephone base by unplugging the electrical power to the base. Wait for 15 seconds and plug it back in again. Allow up to one minute for the cordless handset and the telephone base to synchronize.

•Other electronic products such as HAM Radios and other DECT Phones can cause interference with your cordless phone. Try installing your phone as far away as possible from these types of electronic devices.

There is interference during a telephone conversation. My calls fade out when I am using the cordless handset.

•The handset may be out of range. Move it closer to the telephone base.

•If you subscribe to high-speed Internet service (digital subscriber line - DSL) through your telephone line, you must install a DSL filter between the telephone line cord and the telephone wall jack. The filter prevents noise and caller ID problems caused by DSL interference. Contact your DSL service provider for more information about

DSL filters.

•Appliances or other cordless telephones plugged into the same circuit as the telephone base can cause interference. Try moving the appliance or telephone base to another outlet.

•Other electronic products such as HAM Radios and other DECT Phones can cause interference with your cordless phone. Try installing your phone as far away as possible from these types of electronic devices.

•If your telephone is plugged in with a modem or a surge protector, plug the telephone (or modem/surge protector) into a different location. If this doesn’t solve the problem, relocate your telephone or modem farther apart from each other, or use a different surge protector.

•The location of your telephone base can impact the performance of your cordless phone. For better reception, install the telephone base in a centralized location within your home or office, away from walls or other obstructions. In many environments, elevating the telephone base improves overall performance.

•Disconnect the telephone base from the telephone wall jack and plug in a corded telephone. If calls are still not clear, the problem is probably in the wiring or telephone service. Contact your telephone service provider (charges may apply).

•If the other telephones in your home are having the same problem, the problem is in the wiring or telephone service. Contact your telephone service provider.

56

Page 59 Page 61
Image 60
Page 59 Page 61
Contents User’s manual Congratulations Table of contents Answering system operation AppendixIndex Parts checklist Getting startedTelephone base and charger installation Battery installation Charge lightBattery charging Low batteryInstallation options Tabletop to wall mount installationWall mount to tabletop installation See Telephone base and charger installation onTelephone base layout DeleteHandset layout FlashMENU/SELECT Push to Talk PTT Telephone settings Ringer volume telephone baseRinger volume handset Press MENU/SELECT to highlight Ringer volumeTo manually turn off these indicators LCD languageClear voicemail Press MENU/SELECT to highlight LCD languageKey tone Set date/timeCID time synchronization Home area codeHome area code, then press MENU/SELECT Dial mode WebsiteAnswering system settings Answering system set upAnswer ON/OFF To turn on or off with the telephone baseCall screening Number of ringsPress MENU/SELECT to highlight Call screening Remote access code Message alert toneAnnouncement Play your announcement Record your own announcementDelete your announcement Press MENU/SELECT to highlight AnnouncementTelephone operation Mute Temporary ringer silencingTemporary tone dialing Find handset Call waitingEqualizer To access a number in the directory while on a call To access a number in the call log while on a callTo access a number in the redial list while on a call Chain dialingRedial list Dial a redial entryDelete a redial entry Multiple handset useIntercom Answer an incoming call during an intercom callTransfer/share a call using intercom Push to talk PTT PTT On/OffPTT to a single handset Press MENU/SELECT or Push to TalkPTT to all handsets Answer PTT Change a one-to-one PTT to intercomEnd PTT Answer an incoming call during PTTMake an outgoing call during PTT To end or leave PTTDirectory Store a directory entry Enter NameCharacter chart Characters by number of key pressesSearch the directory Alphabetical searchDial a directory entry Edit a directory entry Delete from the directoryPress MUTE/REMOVE or OFF/CLEAR to Delete contact?Call log Memory matchMissed calls indicator Review the call logView dialing options Dial a call log entrySave a call log entry to the directory Displays Edit NumberDelete from the call log Call log display screen messagesTo delete one entry To delete all entriesAnswering system operation Answering system and voicemailMessage capacity New message indication Call interceptMessage playback To play messages with the telephone baseTo play messages with a handset Delete all messages Record and play memosTo delete all messages with the telephone base To delete all messages with a handsetMessage window displays Window display DescriptionRemote access Command FunctionAppendix Handset display screen messagesCommunication between handset Handset and telephone base indicators Handset lights Telephone base lightsHandset icons Battery Expand your telephone system Add and register a handset optionalReplace a handset Troubleshooting My telephone does not work at allThere is no dial tone Cannot dial outLow battery shows on screen Telephone does not ring when there is an incoming callCharge light is off My handset beeps and is not performing normally Hear other calls when using the telephone My caller ID features are not working properlyHear noise on the cordless handset and the keys do not work Registration failed appears on the handsetCaller ID entries do not match the numbers I need to dial Out of range or No pwr at base shows in the handset screenNew voicemail and show on the display and I don’t know why Cannot retrieve voicemail messagesAnswering system does not respond to remote commands Outgoing announcement is not clearAnswering system does not record messages Messages on the answering system are very difficult to hearCommon cure for electronic equipment Important safety instructions Precautions for users of implanted cardiac pacemakers Operating rangeMaintenance Taking care of your telephoneAbout cordless telephones Rbrc sealWarranty What does this limited warranty cover?How do you get warranty service? FCC, Acta and IC regulations FCC PartIndustry Canada Technical specifications Index Index 91-002897-020-100
Related manuals
Manual 2 pages 59.8 Kb
Top Page Image Contents